开云体育

Re:- I would suggest that you provide feedback to the pipewire and wireplumber

Adrian: Many thanks for the reply ! Linux noob here, but studying. I think I have vb6run (I think SP6) and mfc42 already installed, but I will check. I do NOT have cabextract. I’ll also check the

OK, using Winetricks, I installed VB6, and a few missing other files. I was still getting errors about missing or misinstalled OCX files. I had to retrieve them at OCXme.com. Finally, VARA FM

Thanks Brian. I will follow that up. 73. Dave G0WBX

Thanks Dave 'HKJ. I'll try that when home tomorrow and let you know. One thing that always frustrates me, is the lack of a context driven help system.? However, achieving that would not be a

Bob, I am investigating. David

"Dave, G?WBX via groups.io" <g8kbvdave@...> wrote:

<PUSH> <TXRSID:off> <MODEM:NULL> <CWID><TX><RX> <@TXRSID:on> <@POP> You need to reset the TX RsID and modem restore using the @ predecedent to insure those occur after returning to the receive

Hi. I'm sure I had all this working in the past, but not now....... Not helped by issues with my main PC preventing reliable access to it.?? That is fully disconnected, cold and dead for

From: Dave, W1HKJ Date: Thu, 09 Jan 2025 13:48:52 GMT Pipewire is designed to emulate the API calls made to Pulseaudio. Emulations are not always perfect of course, it takes only one "edge case" and

Wonder if you would review this again Dave. Same behaviour in 4.2.06.19 (yeah I am slow...) What I didn't make clear in my OP was with "Retain tx freq lock" enabled, the operational expectation is

The Country (CTY) Files were updated on 10 January 2025: https://www.country-files.com/cty-3502-10-january-2025/ For installation instructions, start at:

Same here on Fedora 39 and now 41. pavucontrol works fine

Thanks Brian.? Any reports from other distribution users? David

"Dave, W1HKJ" <w1hkj@...> wrote: I've been using pipewire under Fedora for over 2 years now and pavucontrol works perfectly with it here. -- Brian G8SEZ

Pipewire is designed to emulate the API calls made to Pulseaudio. David

Sounds good. Just like I've always had it. It just confused me a little because I'm hearing from the tech world that pipewire is the replacement for pulseaudio so I thought we would have to change the

If you are using Pipewire as the audio controller then simple check "PulseAudio" on the fldigi Soundcard/Devices dialog tab. David

Thanks David, So I installed qpwgraph and when I run it I see a graphical display but I don't see any slider bars to adjust audio. I can see pipewire in my pulse audio volume control application so

Pipewire is supposed to emulate the API calls for pulseaudio.? I do not think that pavucontrol is compatible with pipewire. When working with PipeWire, you can use audio mixer controls like