¿ªÔÆÌåÓý
Thanks Jeff,
I was looking for a solution that fits in the use of hamlib and flrig for the case where the rig gets powered off once started (very rare I know - just trying to make the system fool-proof).
I use the feature in flrig to power on when flrig starts and power off when it closes. So I can always close flrig and reopen it to restart the rig. It would have been nice to know that it had powered off rather than just not responsive.
73 Phil GM3ZZA
From: [email protected] <[email protected]> on behalf of Jeff Kunce, N0JUH <jjkunce@...>
Sent: 20 August 2024 3:31 PM To: [email protected] <[email protected]> Subject: Re: [linuxham] Remote power control #flrig #hamlib ?
Hi Phil -
?
I think I added custom commands for power on/off to flrig in the past, but I wasn't satisfied for some reason.
?
I usually use AI0J's "ICOM Power Tool" python script. I have shortcuts (or shell scripts) to launch it for both power on and off. It gives a little bit of feedback (a message that says if the rig accepted the command.) It is available here:?
?
73
-- Jeff N0JUH
?
|
Philip Rose, GM3ZZA