开云体育

The auto tuner is going back to its last remembered band settings. Normal function as if one had to manually tune to a band using a legacy tuner., Joseph D. Yuna Joseph D. Yuna (LCDR USN/ret.) W4JDY /

No tuner is going to instantly tune to your new frequency, and why would you immediately start talking until your radio and tuner were not done configuring for the new band? Joseph D. Yuna Joseph D.

Question is what radio and LDG tuner? Joseph D. Yuna Joseph D. Yuna (LCDR USN/ret.) W4JDY / EM79xr / ITU 8 / CQ 5 United States of America <mailto:W4JDY1953@...> W4JDY1953@... Sent:

Thanks! 73, Ken KN2D CW Ops #3566 Constant Contact's Top Trainer/Partner Try Constant Contact free for 30 days by going to http://www.TheBestEmailOffer.com Need help with email marketing? Let's chat!

Good thought, Mike! 73, Ken KN2D CW Ops #3566 Constant Contact's Top Trainer/Partner Try Constant Contact free for 30 days by going to http://www.TheBestEmailOffer.com Need help with email marketing?

Thanks, Ken! I think the long press is part of what's going on. Will pay closer attention to that. 73, Ken KN2D CW Ops #3566 Constant Contact's Top Trainer/Partner Try Constant Contact free for 30

Hi J.D., I use both a G5RV and a multiband dipole., I suspect it has to do with the automatic vs. semi-automatic use of the tuner. I appreciate your guidance! 73, Ken KN2D CW Ops #3566 Constant

Ken, If your antenna includes a balun or unun, it may be getting warm after a while. Bob N3FM

What kind of antenna? If the antenna and tuner worked previously and is acting up now I would look at the antenna instead of the tuner. I have seen a lot of problems with end fed antennas with

With regards to the RF in the shack post, see if it happens with a lower power level. If not, it may be time for some ferrites. Mike N3PM

Thanks, Leonard! 73, Ken KN2D CW Ops #3566 Constant Contact's Top Trainer/Partner Try Constant Contact free for 30 days by going to http://www.TheBestEmailOffer.com Need help with email marketing?

Hi Ken (nice name). I too have disabled full auto mode on my LDG tuners because of unexpected tuning. My understanding is the settings are saved; however you need initiate a tune cycle to make the

The setting are saved but if you are on manual you will have to hit the tune button to get it to retune to the correct saved setting.? The memory tune is almost instantaneous when you start

Hey Ken, I had to take it off full automatic tune mode because when on SSB it was trying to autotune while transmitting and my audio was interrupted by the relay chattering to tune the radio. I was

Is this new behavior? I mean, your antenna needs to be “re-matched” to your radio when you change bands, or make large frequency changes in the same band. Is your tuner in full auto mode? Sounds

I noticed this weekend when I was changing bands or frequencies on a band that my SWR would go up, even though the day before (or earlier on the same day), I had tuned my rig/antenna. I use the LDG

I'm not familiar with the Mark V but with my ft710 I have a crossover 1/8 inch cable from the remote plug on the radio and the AT1000Pro2. When I do a short press on the tune button on the tuner it

I cannot get this software to work in Windows 10. Sent: Saturday, March 22, 2025 6:41 PM To: [email protected] Subject: Re: [ldgelectronics] Serial Data issue on PIC METERTX METERRX Stop

Hello I just bought the AT600proii to make using my vintage amp a little easier. I have figured out how to connect it to my ft1200 and use the tune button but can't find anything about the Mark V

Based on the amazing customer service I've received from LDG, they'd probably happily send you the replacement caps. But it's probably faster to simply source them yourself.