开云体育

Hello to all of you I do know from the manual that the YT-100 it is not suitable for the Yaesu F-817, but I wonder if in the meantime there has been some "upgrade" about this matter , in other words,

Thanks for everyone's patience as we upgrade our systems. Here are some updates for May 2022. 1] We continue to get bombarded by Russian hackers that are causing web and phone delays. Here is a sample

Neil, Thank you for the info. I just order the cable from Amazon. Also one of the zip file was a cheat sheet. It gave me the info on changing the watt meter from 100 to 1000 reading.

Daniel, If you have a AT-1000proii the manual is below https://ldgelectronics.com/products/desktop/at-1000proii/ If you only have a AT-1000pro the manual is in the following directory.

Thanks, Ron. Well, problem is that while tuning, the amp's internal protections shut it down when the SWR goes above 3:1. Right now, I'm using a SGC 239 remote tuner, which does tune well on <5W, then

Hello all, I have some questions about the operation of my at-1000pro. 1) what is the plug? specific size for the 12 volt connection on the back of the tuner? 2) It mentions that I change the power

Give them a call as they are very good at customer support. They just sent me on for one of my tuners as it just plugs is to a DIP socket.

Hi Neil, Thanks for info. I downloaded the zip file and found the manual and schematics. No hex file for the PIC.73'sSteliAE6OR

I have burnt the wiring on L2 and wonder if anyone can tell me the number of turns of wire it has and also the diameter of the wire. Thanks in advance Ian ZL2AIM

Stelian, The LDG site is up. If you go to the group site and files you can download a ZIP file on the IT-100 (Includes circuit diagram and manuals etc) For info there are 25 files on discontinued

I may have on that I got to repair a tuner. It will take a while to find it, however.

Hello everybody Just purchased this IT100 and found that the PIC is smoked. Does anybody have one for sale? -LDG is down, not sure for how long. Hopefully they will get back to me with a solution. I

Wiring schematic to connect LDG Z-100 Plus to Kenwood TS-480sat remote head so I can use the remote to activate the tuner.

Hi Lars, I think I can help you on this one, I got a AT-600 PRO 11 with this problem, and I have now fixed it, it was not the CPU, it was a small 5pin comparator that it uses for the remote switching

Hi Lars, I think I can help you on this one, I got a AT-600 PRO 11 with this problem, and I have now fixed?it, it was not the CPU, it was a small 5pin comparator that it uses for the remote switching

Hi Lars i just looked at the diagram in the files section, and it does work the same as the at-600 that i have fixed , there was as short from pin 1, U1 going to the PIC CPU, pin 40, that is the tune

Hi I have 5 LDG AT-100PROii who have the same problem, non of the buttons works on the front, you cant change antenna and so on, is it the CPU who is bad ? but all of them tunes automatically when

Hi folks; I have an AT-600 Pro II that I got back around 2015. I loved it, and it would tune both my antennas, a 102' ladder line fed flattop (through a 4:1 balun) and a 34 foot Eagle One vertical.

Thanks Bruce. I can do that. Eric

I would flip the circuit board over inside the tuner and check to see if one it more of the toroid coils have a bad solder joint.