开云体育

If you are coming to Charleston, you might try Palmetto Detyens yard. It is about 20 miles up the Cooper River, but is one of the few yards with a travel lift wide enough to haul a cat. They are 24

PYI also sells rudder bearings as I had to change the rudder post that were built out of aluminum that corroded inside out.? The new ones are Fiberglass tubes that should last a lifetime with

Thanks Geffroy. I appreciate it. (And your English is great!) -- Paul Bennett Dafne II Lagoon 500 PNG

Thanks Dave. We're in PNG, headed that way, which is convenient. -- Paul Bennett Dafne II Lagoon 500 PNG

try Simpson Marine in Phuket as the Asia Lagoon dealer. https://www.simpsonmarine.com/office/thailand-phuket/ There a few Lagoon charter boats in Phuket that regularly lose their rudders!! Dave Shaken

Hello sorry m’y English is very bad, but you can try: agent lagoon chemins d’océans Avenue Jean d’AGREVE 83400 HY?RES? Contact: Florence BRUNEAU? flb@... 0033(0)494657425

Hello, Sorry my English is very bad! Try: chemin d’ocean. 25 avenue Jean d’Agrève 83400 HYERES FRANCE AGENT LAGOON Florence BRUNEAU flb@... 0033(0)4 94657425 Best regards LAGOON

I need to replace the rudder bearings on my Lagoon 500. Does anyone know where to source these? I find Lagoon HQ in France to be unresponsive.? -- Paul Bennett Dafne II Lagoon 500 Currently Papua New

st Augustine marine center can handle you. there are two yanmar mechanics that can change your sail drive seals tim sv folie a deux L380

One day north to Wilmington, Wilmington Marine Ctr or Bennett Brothers.

Marcus, You aren’t too far beyond Wilmington/ Beaufort,NC. With a 66’ mast you will need to sail back up offshore. Not too bad given the fact that the current and prevailing winds should favor

Hello,?? Been heading South and now It appears I have seals leaking on my sd50 saildrive.? Needing a place to be hauled out somewhere around Myrtle Beach SC. so I can get new seals installed. ?

Thanks for all the input. Unfortunately right now I am a little distant from the boat. ?She is in Florida and I am Downunder in NZ. ?WIll check when I am back nearer. ?Regards. Michael

The correct answer for the standard units supplied by Lagoon is not enough, 2kW is good, 3kW is even better. It is not about the max output on a clear blue day with full sun, but still getting usable

Count the number of cells a typical 250w panel is 6x10 cells and ratio from there. Cells lose efficiency with time but not drastic ie half. Has your system got a MPPT (maximum power point tracking)

Could be anything. Look on the back of one of the panels. Should be a sticker with all the info. Take a picture of it and post it. Rick sv Mai Tai L37 TPI

Happy New Year all. We have 4 solar panels that came standard with the cat. Does anyone by chnace know the output etc of these?...of course I appreciate that depending on the sun orientation and

Thanks for the assistance. Turns out that The hot water cylinder inlet pressure relief valve also has a pressure reducing or one way valve that had simply disintegrated.This was blocking the flow and

John, Is this condition at all faucets and devices? On my 410 I have flex lines both on the intake and discharge of the HWH. I have seen these kink and restrict water flow. The Mixing valve

Hi all we have had a slow deterioration (over 5months) in the hot water pressure and flow. It has gone from being almost the same pressure and flow ?as the cold water system to a trickle, maybe 10%