开云体育

I am going to replace the tired cruising?sails ( http://www.cruisersforum.com/forums/tags/sails.html )?on my 2008?Lagoon ( http://www.cruisersforum.com/forums/tags/lagoon.html )?Catamaran (

We have been anchored in Lamu Kenya for 2 months. Now preparing to get moving and i noticed my B&G 508 wind Transducer is not spinning. There has been a lot of sand and dust in the air from the sand

Thanks for a great answer!!

Not sure about those widespread warnings.? I can't find the story any more, but West Systems did a paper on using gelcoat over epoxy, and found it to adhere well.? Or read this Jamestown Supply

Having arrived in Australia and now running low on gas, I find that the gas bottles cannot be filled and that the Australia gas regulators and hose do not fit the in-boat connection. Has anyone solved

It can be frustrating, but try the shower float switch. You can try putting food die in the tank to help see where it’s coming from.

Do you have AC? Condensation from the AC system finds its way into the keel bilges. Might want to check the auto bilge pump is working too. David shaken not stern L421 Phuket

So you find that despite widespread warnings that gel coat will not adhere to epoxy, that it does work well? Bruce

Hi Bruce GIBCO in Fort Worth Texas have this?Pattern GFBTS 322 (Female with PVA) which matches Lagoon deck pattern. Sold by the foot. I just cut it up into small pieces to repair small areas. They

Usually you would need to widen the cracks to get a good traction on the surcafe, clean and fill back with a little bit excess, sand and wax. There is a bunch of explicit video online on this topic

-- —- David

Check the shower in rear. Mine leaked into this area from engine compartment. The fitting was loose at the mixer valve. If it’s this you’ll see water in engine bilge. Also check freezer drain?

Was a thread on FB group about this. I can't get to it now, but possibly from under the sink?

Hi all, ive got a freshwater leak into the stbd bilge it comes from the freshwater system (not rain!!). The leak fills the keel bilge void in approx 3 days and is getting worse.? I have looked

I have some dings in the non-skid of my 2011 L400. I read everywhere that patches should be made with epoxy. I can make a mold for the non-skid, but polyester gel coat should not be used over epoxy.

Has anyone figured out how this is attached and how to remove it?

Hi, I have a 2018 450S #94, and I would love to have an electronic copy as well. I converted or downloaded every manual I could find. Lagoon manuals were too big to scan. Thank you Anders, Jim Kennedy

I have 450S #6 i would love to have a electronic copy if possible.. mlsinvest@... Thanks Mike

I got mine from my dealer. So I have the 450S and F manuals IF anybody is interested. Greetings, Anders F 450 S #30 Northern Breeze -- H?lsningar/Regards, Anders Friis

Looking fro plan B if autopilot fails. Installing second AP seem cleanest solution but, it is expensive and if current AP works another 10 years, second AP will be close to expired in 10 years as