开云体育

Hello everyone, our Lagoon 440 hull 029 S/y Paradise just lost a propeller somewhere in the Baltic Sea. We have Volvo Penta D2-75 engines with two blade propellers. Anyone with the same engine

The wires run aft but are almost impossible to pull as they are held in place by the gun like substance Lagoon uses to hold wiring looms in place during manufacture. Good luck.

Hi everybody, We are looking for a Lagoon 38,39,40 models 2010 and younger. Max budger 250K USD. Please let me know by PM if you have one in Turkey.

we just found out that our spinnaker and main halyards are wrapped and i can not 'wrap my brain' around how to fix it as the lnes fill up the exits any tricks are welcome tim and tracey folie a deux

does anyone know the path of the starboard salon fan wires?? We have lost continuity of the positive wire.? ours has the black and red wrapped in electrical tape....perhaps headed forward.? tim and

I have had 2 Lipo banks fail on 2 different lagoons and would not recommend them. The real issue I feel is to cruise comfortable you need to simplify systems not make them more complex. Adding any

Hi all, The steering cables run from the helm down to the inside wall of the port cabin, then turn 90 degrees in the port engine compartment. The pulleys inside the rear port cabin are well engineered

Thank you Kevin! I've got 9000 hours on my 3GM30 diesels and SD20 saildrives. I can replace them with 3YM30 diesels and SD25 saildrives for about $30K plus installation. My alternative is Bellmarine

The Lagoon 420 hybrid is a good place to start. There are many discussions regarding this hybrid Lagoon. I have sailed a Catamaran that was all electric. Personally, I like my Beta diesels for one

Nice choice, looks great. How’s the current draw, are you able to run this off the inverter? My concern would be say, baking items for 30 -45 minutes. Did you finish the cut edges of the cabinet,

Microwave I used is PANASONIC NNDF385MEPG A few different models available but the Panasonic slim line ones are the only ones I found that fit in the limited depth of the cupboard where the oven was.

I’m thinking of repowering my 2003 Lagoon 380 with BellMarine electric drives and lead crystal batteries and 48 volt diesel generators. Does anyone have experience with electric drives?

I have long been planning to make this upgrade but I have not found a combo microwave that fits in place of the Eno without enlarging the cutout. I am seriously considering the Sharp SMC 1585BS

Hi Lance, sorry I have no clue. But I am interested to know the type/model "Combi oven" that you found will fit as replacement to the ENO? Sounds like a great idea, and I want to do the same :) Cheers

While cleaning up a few other items on my Lagoon 440, I discovered a spare AC cable under the access hatch in the cupboard below the galley sink. I can only assume that this is located there in case

Thanks for the great suggestions. After cleaning and placing paper towels to show water it turned out to be spurting out of the overflow tube that goes to the top of the vacuum breaker on the sea

It could also be the raw water hoses from seacock to strainer and to engine. I had a bearly visible cut in the hose just where the hose connects to the strainer with the clips that built overtime due

It's probably the sail drive rubber seal between the hull and sail drive unit Usually there is a double seal with an electronic sensor that would give you warning of a problem. Best have the problem

My starboard engine ends up with the cavity underneath the engine full of seawater and overflowing into the bilge after an hour or two motoring at 2300 rpm. I thought it was the salt water pump, but

Hi all, We have a 450. ?The thermostat for the freezer in the salon has died and a new one is on order. ?The repair guy spend a great deal of time trying to figure out how to take out the drawers