开云体育

Komkit or anyone, Would you be so kind to tell me what connections you have between the 991a and the LA-1k? I am a bit lost and confused Dan Ehrenfeld

When I turned my LA1k on today the display has changed. The numbers and lettering are all blue now. Is there a problem? I kinda like the blue.

Just a FYI to readers, the latest firmware revision (1.08C) has been posted on the Palstar website.? Thanks " Allow the displayed frequency to show any changes for only 20 ms after the PTT is

I have a?1500 watt RF output retrofit/upgrade modification for the Palstar LA-1K and I hope its manufacturer will contact me.

Interesting. I also have the ftdx5000 and i used to have issues before i repaired all my connectors and some coax cable and even a balun. Sounds to me like its the amp then. Mark is helpful. I spoke

Thanks Barry. My replies are not getting posted until "moderated" maybe because I am new. I am using a dummy load.? Also using a band cable and direct keying.? Have tried with and without band

Hi Dennis.? I am using a Yaesu FTdx5000mp. Since Dave posted the original message, I have swapped out the LA-1K for another SS Amp ( TokyoHyPower ) and the THP SS Amp works flawlessly.? That

Was just thinking. Stick with the dummy load at this time. Did he try ssb? If its ok with ssb on the dummy load, it could be a keying thing. Ive read, depending on the radio, it could be a setting in

I would always use the direct cable. That eliminates one issue. Does it on a dummy load? Hmm. Sounds like either a bad patch cable or rf. Or maybe just a bad amp. I would have him call palstar if he

Thanks.? My friend is monitoring this, awaiting approval to post.? Right now the issue is with a single coax going to a dummy load.? Moving the amp around appears to have fixed temporarily.? Its

Once u use the direct cable u eliminate one issue. The rest is troubleshooting each coax. Each coax connector ( i physically went through each connector one at a time and focused on only 1 antenna,

I had issues with my amp at the start. Rf sensing indeed NOT. Solution for me was use the band cable connect it to the radio. Problem resolved. [email protected]> wrote:

Quick question, what exciter are you using? I had the same problem with only ONE of the seven transcievers I have here. The Kenwood TS-890s exhibited that problem. I sent it to Kenwood twice and

Brand new LA1K.? Current firmware.? To keep it simple, we will go with the dummy load first. I will copy/paste his reports to me.? If ANYONE has a clue, please let me know.? He bought the LA1K at

I drive mine as low as 5 watts a lot. Been using it over a year no problem.

Does it hurt anything if I drive the amp with 10 watts?

Absolutely the greatest support from any factory I’ve ever dealt with. K4OCS Barry ?

Just purchased LA-1K and had trouble getting it going. After a few talks with Mark, it turns out my problems were with the transceiver. It now works flawlessly. I wish to thank Mark for his patience

Made the Direct Connect with no problem. Thank you Mike,Kent and David! Not to much on CW anymore due to arthritis and nephropathy in hands so no worries there with QSK but good to know Kent. Happy

Thanks for the help. I didn’t think it was necessary but didn’t want take the chance. Good info… De k2HVE Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 Sent: