开云体育

Works fine here. Whats your error message?

Further to this, I have also tried sending CW out on 10m via my 3 element beam. CW is totally fine until I move down to 28.002 Mhz or lower. Then it does the same bypass as it does on the entire

Thank you for reply. I think your correct. Im going to investigate my 17m antenna further. 73 Sent: August 8, 2020 1:43 PM To: [email protected] Subject: Re: [la1k] SWR High SSB ONLY -

The swaying is not a major issue except in high wind gusts. I’m leaning toward the belief that the LA-1K is susceptible to momentary SWR spikes that happen so fast they can only be detected (in my

Kent, 2 questions answered as a matter of fact. When i say now, that means, since i used a serial cable to the back of the amp using direct mode. Thats what now means. Since going direct mode.

Kent, All i was asking is if you resolved your tree swaying issue. Your now asking me a question in reply and expect an answer? How does that work?

As I have reported before, I am also having this issue, but in my case it is only in digital modes. I can run SSB without issue, low or high power, but if I try to do a digital mode it will eventually

Barry, When you say “now,” what did you change that made things better? Kent K9ZTV

Inverted vee. Im considering it could be an antenna issue. But whats odd is why ssb and ft8 or rtty ok on 17 but not cw?

The fan noise when it’s idle or the fan noise when it gets warm? 73, Bernd – KB7AK Sent: Friday, August 7, 2020 3:08 PM To: [email protected] Subject: [la1k] FAn noise Has anyone tried

Barry ... What antenna are you using on 17?

Has anyone tried putting any sound deadening in top of the cabinet to help with fan noise?

Kent, Did you resolve the swaying? tree problem? I? am only having it go into bypass mode now on 17m CW. 17m Digital is fine. 17m? SSB is fine. What would cause it to only go? ?into bypass mode

BJN644, I had the same error on my Windows 10 machiine. ?I found I needed to replace msvcr100.dll. ?You can obtain a new copy from any reliable source. ?I used Wiki DLL. ?You will be given a

" The application was unable to start correctly (Oxc000007b) click ok to close the application." That's when I click on " Load_LA-1K " I don't even get to? plugging in the USB cable so it's not

What error message if any do you receive. ?If the problem is that the installation software is not running let me know . . . I may have a solution for you. 73 Howard AA9HB

What error message do you receive? ?Is the installation software not running? ?Let me know if this is the case . . . I may have a solution for you. 73 Howard AA9HB

I had to use both a different Win PC AND different USB cable. Also, did not like Amazon Basics USB-A extension cable. Third USB A-B cable worked. The firmware does load fine once you have worked

Also, just be aware all USB B cables are not all wired completely through. It is fairly common to struggle trying to connect to hardware without realizing as the operating systems don't tell you

My friend went through three computers before finding one that worked.? Something about the updating software isnt quite right, or it might be the version of USB drivers, or even the USB chip the