开云体育

I run temporary on 120v and get 400w out easy.

Backordered? Wow, i,heard they were selling alot during covid. Good news.

Think I figured out a way to have 220volts.looking forward to using the amplifier. I ORDERED IT today but there backordered.

Before I ran my 240V line, on a pretty heavily used 120 circuit, my whole shack with computers and audio gear on it, I was getting 700 out before it would shut down from the sag (never blew the

I get 1k out with mine on 240v.

Too bad you don't have an electric stove close by to tap into the 220. I get about 900 out pretty easy with a 1:1 swr on 6 meters and about 45 watts in. Paul

Thinking about buying a LA-1k? ?What power output should I expect on 6 meters? I will running on 120 volts.

I have a multiband yagi that covers 6 thru 40m.? ?On 40m, one of the capacitance spokes on the director fell off, and the SWR on my net frequency went from 1.5:1 to 2.0:1. The finals in the LA1K are

New information from experimentation If I run the autotuner with the Amp in Bypass mode, I tend to get a better SWR match than if I just ran it in OPR mode.? 1.04 vs 1.55.? ?80M May be my

I use direct PTT keying of the amplifier with TX1 and my normal transmit profile uses TX1 to key it. My TUNE transmit profile disables TX1 so only the 10W from your Flex goes through.

“So, question: Why do they say its a perfect combo with the HF-AUTO, if the two dont talk to each other? Sounds to me like it is the same as using any auto-tuner then." Marketing ? They

Good point.? I just key mine for a second, and let the HF-AUTO retune to its preset.? I don't even have to go through a full tune cycle here (holding the radio in TX mode) since initially setting up

Good Afternoon, I have the LA-1K/HF Auto combo. Firstly, I would never ask the HF-Auto to tune with the amp in OPR mode. If it's in OPR once the SWR gets below 2:1 the amp will automatically

no, it is certainly not a dumb comment.? ?If I have the flex set for tune power 10 w, and RF power 30 w,? and I? select TUNE? on smart SDR,? ?while the auto-tuning? occurs, the HF-AUTO Watt

If you can't find a replacement I'd ask Laurent F6DEX to sell you a copy with strict understanding support will end in couple years in 2022. Perhaps he will make an exception for LA-1K

This may be a dumb comment, but since the amp shuts down if the SWR is high, if you leave it in OPR mode, when you go to tune the HF-AUTO the amp will turn off, the HF-AUTO will tune, then the next

Just went to the TRX-Manager website, and looks like the developer isn't selling the program anymore, but is supporting updates only to previous purchasers. Disappointing, as I just got my

Keep in mine that if you're using a wire antenna that is not solidly secured and susceptible to doing a jig when the wind blows, your SWR is going to be all over the place regardless of how good a

Terminate the amp-tuner into a known good load and see if the condition exists.? If it does, then I'd call Palstar and see what they can suggest.? If it goes away, then I recommend a closer

Keith, have you resolved your issue? Its been awhile And would like to hear how it went? I have same issue is why.