开云体育

a new amp works great on all bands but 15m.. swr 1.2 . with 45w output only 650w.? ?any ideas

Hello Barry Thanks for your report on the LA-1K. So far I am quite happy with the performance of mine. Running on 120 V for now. I may bring 240 into the shack but in order to do that I will need to

VE3PP Congratulations on your new LA1K. I’ve had mine for around 4 years now. I gotta say I did have some growing pains with this solid state amp. I used to have a HealthKit sb220 and this solid

VE3PP I wasnt questioning your setup, but the person who originally asked you questions about your results. I totally understand your results.? SWR on the Palstar can cause the power meter to read

Hello Dave N5DDD, Sounded like you were referring to my 5-Apr-2023 post /g/la1k/message/1184 when asking those three (3) questions. I was putting together an antenna system (antenna

Yes I used a dummy load. No I did not use a calibrated BIRD wattt meter. Plus the difference of 40-50 watts between meters isn't going to make a damn bit of difference on the receiving end! And yes

<The rest of that 5-Apr-2023 post called into question how believable is the LA-1K SWR readout, as observed. 73 Ray KJ5MI> Did you calibrate your LA1K power meter against a known calibrated watt

With my watt meter. Autek WM-1 and the watt meter in the HF-AUTO.

Hi Rick, How did you determine the respective RF output figures? Additional input: Please check out my 5-Apr-2023 post /g/la1k/message/1184 where you can click through to my video

I finally got my LA-1K this week and have it in line. I am running it on a dedicated 120 V 15 AMP circuit. So far no problems at that voltage. 20 watts drive, 600 PEP output. 25 watts drive,? 750

I also just use the RF sensing function for band switching. Works just fine, 4+ years, ICOM 7300, then SunSDR2 Pro, and now a K3s. 73, Roger VA1RST wrote:

I use my LA-1K (and HF-Auto tuner) with both an Icom IC-7610 and Yaesu FT-991A. Don't use any band switching cables - the amplifier's automatic RF sensing works fine for me and eliminates the

Hi Bill, Dan at Associated Radio has my order for one cable.? Thanks for pointing them out. -- Glen, WB4KTF, Austin, TX Licensed since 1968

I found that I had a bad cable. The amp works fine now.?The ptt phone plug on the transceiver came undone when I swapped out the old amp.?Sent via the Samsung Galaxy Note9, an AT&T 5G Evolution

Are you using only RF sensing, Les? Please refer to my post /g/la1k/message/1436 for additional thoughts that might be helpful to you. 73 Ray KJ5MI

Is the SEND PTT cable connected and working? 73

Sent: Tuesday, December 12, 2023 8:45 PM To: [email protected] Subject: Re: [la1k] No power out solved Bill, I searched the Palstar website and don't find this band data cable. Where did you get

I found these cables at HRO. I tried to email Palstar to confirm they are the correct cables, but was not able to get a functioning email

unpacked plugged in and went through the settings.? selected mode to operate and it switched to the band just fine.? can see 40 watts drive but very little output. my guess is about what i am

The Ameritron cable works. Also, you can build your own or have custom cables built quickly and economically by: https://associatedradio.com/home.php . ( https://associatedradio.com/home.php )