AMP FAULT CONDITIONS for V1.01B FIRMWARE
1. SWR TRIP FAULT:?Fault SWR stays on display until unkeyed.?Occurs with 2.5:1 SWR. SWR numbers also turn RED.
?
2. TEMPERATURE FAULT:?When temperature reaches 100 degrees C, display shows fault TEMP + unit goes to Standby Mode and can’t enable until below 70 degrees C. Numbers turn red at 70 degrees C.
?
3. TX WAIT FAULT:??? PTT is closed but no RF Applied.
NOTE: Frequency readout must show a number from previous transmission for this otherwise it shows TX BYPASS.
4. TX BYPASS FAULT: F = RED?Lock-out frequency example: 27 MHz
5. TX BYPASS FAULT: F = GREEN?Unit is in STBY – NORMAL.
