开云体育

The big thing would be the ability to put the amp in standby so you can use the antenna tuner. The ability to power on and off would be a bonus as well.

Guys: What would you want it to do? The amp already does a pretty good job of band selection if you don't have a radio that will work with the band selection inputs. The only other thing would be to

Please do. I'm on the website now. Sounds too good to be true.

I just emailed trx manager, I'll report back if I get a reply.

Watching and interested also. Would be remote 7610 running RS-BA1 V2.

I'll check it out, thanks !

Apparently can be done. Worked a Colorado ham recently, he was running his LA-1K remotely using TRX Manager software. Mike KB7ME Sent from Mail for Windows 10

I guess not.

Now that I have my new Flex 6400 that I can easily remote into, I was wondering if there's anything in the works for remote use of the LA-1K ?

I did download it from Peter's link and it came up as 1.02?? I will try it again TNX Rich Neil

I downloaded 1.03D yesterday and it installed 1.03D ?? *From:* [email protected] <[email protected]> *On Behalf Of *Neil Foster *Sent:* Thursday, October 25, 2018 1:19 PM *To:*

Pete, Shalom, I downloaded the link and it had 1.02E and not 1.03D Nachum (Neil Foster N4FN)

Thanks normal on LSB *From:* [email protected] <[email protected]> *On Behalf Of *Dennis McCurdy *Sent:* Wednesday, October 24, 2018 6:52 PM *To:* [email protected] *Subject:* Re: [la1k] LA-1K Firmware

Question: I am transmitting on 3.950 on my 7300 and the Amp reads 3.949. I have not upgraded to V1.30D yet Thanks

Hello all, LA-1K Firmware V1.03D Released: http://www.palstar.com/en/la1k/ 73, Pete Kovacs Webmaster Palstar, Inc.

Thanks for you replying, Dennis. Yes, it's very frustration and disappointing when new piece of ham gear fails. I appreciate your thoughts and suggestion. I hope to have it on the way back to

Hello there Bob, Try Keying amp in RTTY , then switch to SSB.? Idle Drain Current ( ID ) s/b 2.1A. If it's ~.9A you have a blown LDMOS chip. rgds & good testing, Mike N7KR

Had something similar happen to my LA-1K after about an hour of use(it was just a few days old). One of the LDMOS's died. I called Palstar, we ran some tests and I was told to send it back. So I boxed

Hello there Bob, Try Keying amp in RTTY , then switch to SSB. Idle Drain Current ( ID ) s/b 2.1A. If it's ~.9A you have a blown LDMOS chip. rgds & good testing, Mike N7KR

Hello Bob, I tend to think you have a problem with the amp. If you continued to run it with 40 watts of drive on RTTY it should continue to produce 1kw until it overheats and shuts down at 100