Re: LA-1K Trips to Standby in SSB mode only
|
I had tripping issues. All I can tell you is Don’t drive the amp more than 45w. 50max and not more than 1000w output. ? - What is the SWR?
- What band does it do it on?
- Check your Coax ends to the band its doing it on.
- Replace or resolder the Coax ends and DO THEM PROPERLY. (eg: don’t knick them or introduce possible short during high power)
- Same thing with your antenna.
? This is all I got. Hope it helps because it helped me. ? 73 Barry VE6UM ?
toggle quoted message
Show quoted text
From: [email protected] <[email protected]> On Behalf Of Thomas NE7X
Sent: August 15, 2022 10:37 AM
To: [email protected]
Subject: [la1k] LA-1K Trips to Standby in SSB mode only? My LA-1K keeps tripping to stand-by when I drive it on SSB.
On CW, RTTY or FM/AM, I can key the amp with 60-80 watts drive and get full 1200 watts carrier out, no issue. Keys/Unkeys/ no issue.
However, when I operate SSB, if I drive it with more than 20-25 watts, the amp goes into standby. With only 20 watts drive I only get about 700-750 watts PEP output.
I tried adjusting the ALC, does not seem to make any difference what ALC setting I have.
Any suggestions when might be going on?
NE7X...
|
