开云体育

Excuse me John, I had not been clear at all. My mistake. Mandatory is in my applications because power lines are the ones that pose me most of the problems in logic boards. My boards are dense, all of them are routed on component side. And I said mandatory because of the net name change between one side and the other of a 0-Ohm strap. In this case if I have to route a line between an IC gnd to the gnd, jumping? over other lines, and use a jumper, the IC side of a the jumper must not change its gnd name and THIS IS a real problem causing conflicts. You may ignore some of the errors but that's quite messy for me.

Instead of naming this part as "lnk" or "strap" or "jumper", I probably had to name it "net transfer component".

The purposes of this special part were to keep the net name, include this component in the BOM and make the error check happy. In addition it's identified on the electrical drawing.

Just for my information, when you have tested it, please tell me if it still play a helpful role in the last version of Kicad or if it's redundant with a new function that I don't yet know. Thks.