Re: Ignore courtyard DRC and library update
|
I think you can make FreeCad to do these kind of collision detection.
I usually do it manually though.
Lev
On Thu, Feb 29, 2024, 13:10 Clemens Koller < cko@...> wrote: Question in this context:
Is there a way to define a "keepout area" below the LCD for components
lower than a defined height? (i.e. to use the space for passives < 1mm bit
not higher.)
Regards,
Clemens
On 29/02/2024 04.22, brian wrote:
> 1) I also have a board with an LCD. I simply made the courtyard around
> the connector. The courtyard does not have to represent the outline of
> the part, you can make it a dot if you want.
>
> 2) I haven't figured out the migrate button either.
>
>
>
> On 2024-02-28 4:45 p.m., Lev wrote:
>> Hi all,
>>
>>
>> Thanks for KiCad 8
>>
>>
>> I have two questions regarding KiCad 8.0
>>
>> 1.
>> I have an LCD on my pcb, and have a large courtyard for it. Under my
>> LCD, there are lot of other components. When I run the DRC tool, I get
>> many false courtyard overlap errors. Is there any way to squelch
>> these? They might shadow real errors.
>>
>> 2.
>> I see a migrate library button. How does it work? If I push it, it
>> says I shall select libraries. If I select them, it says the same
>> error message.
>>
>>
>>
>> Thanks,
>> Lev
>>
>>
>
>
>
>
>
>
|
