Question in this context:
Is there a way to define a "keepout area" below the LCD for components
lower than a defined height? (i.e. to use the space for passives < 1mm bit
not higher.)
Regards,
Clemens
toggle quoted message
Show quoted text
On 29/02/2024 04.22, brian wrote:
1) I also have a board with an LCD. I simply made the courtyard around
the connector. The courtyard does not have to represent the outline of
the part, you can make it a dot if you want.
2) I haven't figured out the migrate button either.
On 2024-02-28 4:45 p.m., Lev wrote:
Hi all,
Thanks for KiCad 8
I have two questions regarding KiCad 8.0
1.
I have an LCD on my pcb, and have a large courtyard for it. Under my
LCD, there are lot of other components. When I run the DRC tool, I get
many false courtyard overlap errors. Is there any way to squelch
these? They might shadow real errors.
2.
I see a migrate library button. How does it work? If I push it, it
says I shall select libraries. If I select them, it says the same
error message.
Thanks,
Lev
