开云体育

You could also try DigiTrains (by Gyori Belazs) which also works on Android and talks to JMRI. I have both DigiTrains and Engine Driver on my phone, so I can use whichever I feel like. Ian Morgan

I've seen close lightning strikes (tree outside the building) where the induced voltage in internal-only cabling has been sufficient to destroy (blow the tops off) chips (including opto-isolator

Several years ago we had a power surge due to a nearby lightning strike. It burned up the compressor motor to the heat pump. Didn't damage any Digitrax equipment but fried some chips in C/MR-I. I

Well probably the cheapest solution then is to disconnect the Loconet cable (6 conductor flat wire) at the entry / exit from each of the metal boxes. Easy to do but a pain. That way if there is a

I have a Lenz based system using signal mast logic and full occupancy detection using Lenz and LDT kit. I can run dispatcher and autotrains on a simple loop, turnout and signal heads all change and

same solution. Total isolation with fiber optic. I do not know what locket uses for a transmission media. RS485 2 wire, ??? There are isolators for all industrial networks. If nothing can be found for

Those system names ( IH:SE8C:"LT257";"LT258", IH:SE8C:"LT259";"LT260"...) are correct. Peter

I am new to model railroading, and in the beginning stages of setting up an N scale system. I will be using Digitrax products so I will be using the SE8C for signal control. I have finished R.

While the Sound Value decoders have reduced features than a Tsunami, I wouldn't say it has very limited capabilities. They are actually very good decoders. That said, the OP is talking about the DCC

No, he is using Loconet through the piping.

Thank you everyone! I found it!! Jay

Harry,?I have 1 Bachmann soundvalue locomotive, ?a GP40-2, it came with a Tsunami OEM, ?and VERY ?limited capabilities, ?but it does support speed tables.It has pre loaded ?ones, as well as user

The only way to stop this is with total isolation. It sounds like you are using ethernet for the network connections. NEVER EVER leave a structure ( house ) and go to any other structure and run

As a first hit (no pun intended) I would run an earth wire down the inside of the conduit and use it to connect the metal boxes together. Use a heavy gauge wire such as used for connecting house

Look Here: https://enginedriver.mstevetodd.com/ jmriusers@...> wrote:

WiThrottle is an iPhone app. As listed below Androids use Engine Driver. Both work with JMRI software Kurt [Non-text portions of this message have been removed]

Engine driver

Yes it,s called engine driver.

I can't find WiThrottle for my Android phone. Is there an equivalent for Android? Thanks!! Jay

This may not be related to JMRI but I am sure some of you are using the Digitrax Loconet electronics and some may have experienced this so I am putting this on the board for discussion. I have have