开云体育

Hi All, I've summarised the differences below: If not show below the RDG 1968 Rules did not have it. F/Color - Denotes "Flashing. Clear: NS All the same in JMRI RDG Same as NS JMRI, but also has Green

Hi.. It's the file 'BranchPoints.xml' in the Scott Rixon folder. When I open it, I can see my config.. I'm not 100% clear on what it's saying, but I see the reference to the background image, the

Hi Bob Thanks for the reply. I have searched for the NamedBeanBundle_en_GB.properties file but do not appear to have one by that name. I only seem to have five .properties files and none of those are

See below: The "magic" elsewhere extracts all CV numbers defined in Variables and adds them to the CvTableModel. If there is a Variable that has CV="57", it should show in the CVs list but not

Jerry, Responses on your various comments: The CV pane is a particular pane that is built automatically. It will collect all CVs that are valid in the decoder definition, regardless of the fact that

If the USB tab in the Apple System Information report does not show a "CP2012 USB to UART Bridge Controller anywhere in the list (click arrows to open up all Buses and Hubs) AND you have done a

JP With JMRi your must do the reset on the programming track. Walt

That is a very premature and unlikely conclusion. There are many factors (hardware, software, firmware and settings) that can prevent an NCE USB from working properly. Faulty NCE USBs are very

Thanks Alain, Bob, and Dave. To respond to all: I had read (a few times) the help sections Bob referenced on creating Decoder and Programmer files and was into tracing down the XML for panes, but then

I'm trying to reset my Econami 200 diesel decoder back to factory defaults by changing (or entering) 8 to CV8 on JMRI (as instructed by the Soundtraxx manual). But for some reason CV8 does not change.

Sorry, Dan -- I didn't realize that's what you needed. I've deleted the former Build Report from the files and uploaded the "very detailed" one. Same name. But doesn't it stand to reason that the

Hi All, Sorry for the delay because of the difference between USA & Australia. This is the website where I found the 1968 Reading - Rule Book. http://www.rrsignal.com/railroad/towers.htm

Trouble shooting programming track problems DCS is you Digital Command Station GENERAL If you have a large hand held throttle read CV8 with it If this fails JMRI can not read or write CV’s on the

i have changes usb cables and tried a my lap top the usb tab did not see the usb interface so i have to assume that the interface is not working and needs to be returned what are your thoughts Gordie

Tonight I tried to set up a switc list.? Using the trains portion of operations, I was able to build two or three trains then the program crashed.? I finally was able to get my trins sorted by

I have changed usb cables and tried both my desk top and laptop and both computers do not see the interface so I would assume that the interface is bad what are your thoughts Gordie Connelly [Non-text

There might be an easier way, but to make a permanent change you’d change these two lines: TurnoutStateClosed = Closed TurnoutStateThrown = Thrown in the jmri/NamedBeanBundle_en_GB.properties file,

I have seen forum posts regarding how to change the text displayed to allow Closed to be displayed as Normal etc to match UK practice. Unfortunately I didn't save that information and now I can't find

Linux Port Troubleshooting Instructions: ============================= Open a Terminal window and put in this command EXACTLY (except for the double quotes): "while : ;do clear;ls -lt

CVs only show on the CVs pane if they are defined by a variable (see the links Bob gave you). Variables show on one of the other panes if there is a name match in the pane to the variable name. So it