开云体育

are passenger cars included in the cars database and engines used only to run passenger trains included in the engines database. is each individual car included as a separate item or the set listed as

The computer running JMRI my have both a wired and a wireless connection to your router. WiThrottle advertises on all available active connections. -- Dave in Australia The New England Convention 2018

Thomas It sounds as though the earth connection has come off the command station and static is jumbling the memory. Do a full reset on the command station - with power off, hold down the enter key,

Thomas, If you are on Windows, open a command window and use the command: Ipconfig That will list each possible connection interface and what, if any, address is associated with each. If that is

As far as I remember, the limit is 255, but when it gets that high, you should clear them out.

Our club PC with JMRI is connected to an EasyDCC system. Been working fine for years. However, or last several operating sessions, the system has gone nuts. Loks moving and reversing without operator

Our JMRI server automatically loads WIThrottle when it boots. After a kerfuffle last week, it is showing and broadcasting 2 IP addresses, and not showing the port number. 168.2.1.2 and 168.2.1.8 are

Not a problem! Happy to be able to get you a fix quickly. (I was a little worried about that, as 4.13.1 was already well along in the pipeline, so the next chance to publish a fix would be a while in

Good catch Jim. 4.12 it should have been. I need to proofread my notes more carefully.

I think you mean update to 4.12 since 4.10 had all the problems. Jim

Tackling some of the more obvious issues, in the reverse order. Please update to JMRI version 4.10. It is difficult to sift through problems with outdated versions, and 4.10 had several issues we

Steve - good thought. I am going into the club for further tests to be sure I have all the facts. I think I'll find all the Preference settings to be OK since ED v2.15 and ED v2.18 still seem to be

Hi. Please can someone help.I have a few issues.. 1) I have a 4 ray turntable on my layout. Each ray is allocated one of? 4 DCC turnouts . If I set turnouts to "closed" in the edit turntable dialog,

i believe i can write to the decoder as i can change the address even though jmri couldnt identify the engine , cant read the cv’s and gives errors on writes. but after sending the write command to

The 4.12 release is only out for two weeks but I guess I should have installed it before reporting this problem. I just did and the problem has indeed been resolved. Sorry to have wasted your time on

I’m able to recreate this in JMRI 4.11.5 (which you’re using), but not in 4.12. So I think it’s been fixed somewhere along the way. Bob -- Bob Jacobsen rgj1927@...

P.S. ?I am able to repeat the problem. ?I open the panel file that has two lights defined. ?Go to the lights table and turn them on and off. ?Then I delete one and try to save panels and

No light controls; ?no other configuration other than defining a CMRI SMINI node. As I said, a very simple test... ___________________________________ jerryg2003@...

The trace below indicates there’s a bug in the Light-handling code for some system. I tried to recreate it with your description (2nd quote below), but couldn’t quite. Perhaps I’m not reading it

Peter is looking into the EngineDriver crash. This new issue with the upgrade to JMRI sounds like the well-known "Defaults" issue. Go into Preferences, Defaults, and make sure you have everything