开云体育

I use Layout Editor and OBlocks? ;-)

Is it worth mentioning that the answer will vary depending on if you use Layout Editor and OBlocks or Panel Editor and Blocks? -- Chris White

Hello, Sorry for my approximate language: -) Roger replied, and I think I'll do the same by using Dispatcher. Is this the only solution? My goal is to see on the screen in the layout panel which train

I know of one layout that uses CATS and OperationsPro to move the loco icon, so it can be done. Dan

See my original comment, you can pull and set out anywhere in the train's route.? It doesn't matter if the train is a turn. Dan

Ken S, I presume you mean the data LED's on the USB board? Seeing them flash is sometimes tricky. Bigger issues are when they become stuck on, that's a different case of issues. -Ken Cameron, Member

Hello Ken C. Since the LED lights do not work, I am checking with NCE today. I guess the problem must me with the USB interface. I will recap conversation with NCE after I talk with Ed. Ken S

Dave H, Just to remind me, if the cab id is not valid in the USB, we still get the AA command acknowledged, but we'd not be able to talk to the command station, correct? I don't think that is any part

Marc and Ken, There are other possibilities for the AA timeout, such as a failure of the 12VDC power via the cab bus cables to the PCP, or a locked-up NCE USB board (the Cab Bus LED will be stuck on).

There are no separate calls. It’s just a calculation done in various modes depending on how the speed steps, etc are configured. The call into the system-specific throttle always uses the 0. - 1.0

I am looking for the set of methods in JMRI that support the Decoder Pro Advanced Throttle functions for sending throttle commands based on speed steps (instead of the JMRI throttle that takes a

Geoff write a py script. I assume you have one like it and made the edits as required. Sounds like perhaps your relay is not being driven thru the library with a PWM signal?? REally do not know what

Dan, Started setting this loco move up and 2 thoughts came up 1)is there away to pickup and setout in route with one train even if neither location is at the either end of the route and 2) can the

Ok I'll give it a try it will take some time to make the changes I need to work through several trains to be able to set it up and see what happens Thanks Matt Greenwood

I saw your question but did not know exactly what you're trying to do.? My guess was you wanted to have the train markers on a Layout Editor panel show up automatically and move when the train was

Yes, your manifest and switch lists will be updated. Dan

Hi Bob, Thanks for all those comments and pointers. Since way more people are using these than I had imagined, I will try to incorporate these and test them with multiple USB channels when I can pull

Hey Dan, Thanks, I assume that I do this edit after I build the train.Will the add show on the manifest (the pickup and the dropoff at the properly location)? Thanks Matt Greenwood

I started JMRI long before the consisting tool, and never got the habit of using it. Which is why i never saw the option. And training all 60 club members how to use a new tool is not trivial either.

I think those changes will do it. Another approach would be to pass the output stream into the listener objects, so that two separate copies of the class wouldn’t be needed. Bob