开云体育

splasher, It is possible by using different Profiles, but both sharing the same User Files. Check near the top of the system log for the Profile each is presently using. You can have DecoderPro and

Thanks all, I have to do a bunch of stuff before I can accurately respond. It would appear that in these replies resides the answer. There is a HUGE upside to this! I will have a much deeper

Stefan, Below is the correct procedure for reading ESU decoders. As you can read below, the "ERROR - Variable=xxxxxx; Busy goes false with state IDLE" errors in the log don't indicate a failure to

Terry, In your on-line profile (you did make two profiles, one for off-line and the other for the on-line layout?) check the Edit->Preferences->Defaults. There, everything should be pointing to the

Dave, I removed loading the Layout from Edit->Preferences->Startup so that the layout was not loaded. Success!!! The Auto-switch (AS) kicked in and it did a few CVs in the 250 range, then started with

You have the "start" voltage which is cv2, value of 0 - 32, "middle" voltage, cv6, value of 1 or 0, cv5 already discussed, and the reset which states to put cv125 to 1 but the verbiage is listed on

I agree Ken, this is why I was or am confused. The migration should have been easy. In my LogiX Conditionals for ” lever Normal” and “lever Reverse” the “Action sets turnouts LT101 – LT108

At the session with the problems were their any visitors or other people around that had phones but we not trying to run withrottle? Jim

I believe that JMRI sets the fast clock to 24h for Digitrax and 12h AM/PM for NCE. Is there a way that WiThrottle can take the 24h fast clock data and locally display 12h am/pm. I tried setting the

Update: With 4.19.2 running I had a session with 9 operators, all with various smartphones, and everything was pretty much perfect. (The "Stress Test" I was mentioning.) The crew was 100% *different*

I'm thinking that uploading the panel would be in order so others can see the panel file itself. It is quite normal that some items are Internal. Display items, being in JMRI, are generally Internal.

To reset the MRC decoders, I believe you write a value of 1 to CV125 As I recall, the top speed is controlled by CV5, but the maximum value is only 32. I would try a value of 16 and see how much that

splasher,

Terry, Cliff He has his levers (IT) and sensors (IS) setup as "internal".? Isn't true that items starting with an "I" mean "internal".? If so these levers and sensors are not going to see any

Tom, Trust the JMRI Resets menu for decoder reset procedure, not "usually". There's no defined standard for resets. Doesn't even have to be CV8. The only NMRA requirement is that you must not actually

Terry, One further step that I intended to include in the previous note. __IF__ your DS64s are connected to your LocoNet, then wJMRI PanelPro running and - with NO panel loaded, - with with the

Stefan, The problem was that the raw DCC packet (M and P) commands expected a DCC packet minus the checksum byte, but that wasn't documented. JMRI NmraPacket generation code always creates a complete

Terry, With one huge paragraph to work from, multiple snippets have been isolated. It has taken more time to split out the details than to figure out if a response is needed. From what is written

How about trying a factory reset, Usually CV8. And usually a value of 0. Can anyone confirm this for this MRC decoder? Thomas Cain Indianapolis, IN atsf93@... See my NEW website and layout at:

Hi I programmed and read all my decoder with JMRI and printed out the sheets. Now if I have a couple engines on the track they both go. I checked some with decoder pro and they had the same engine