开云体育

The following files have been uploaded to the Files area of the [email protected] group. * /ProblemsBeingWorkedOn/P&G RR 305.xml ( /g/jmriusers/files/ProblemsBeingWorkedOn/P&G RR

Martin, Thank you for finding this serious problem. It helped that you identified the point of failure. Dave Sand

Due to a change at 4.21.5, Logix definitions that have more than 1 conditional may have unexpected behavior. This will be fixed with test release 4.23.3. Dave Sand

While I like the elegance of Dick's proposal, I have two comments: 1) Dick's suggestion depends on a particular behavior of the detection hardware - it _cannot_ be the type which reports "occupied"

Dave & Peter: My mistake on the ID is Duplicate error. I did have a duplicate ID! You can ignore that error. Chuck

mdieckmann, One easy trick is to use a block detector to measure a resistor connected to the track power. If track power is 'On' then the "Block" will show as occupied. Dick :)

That depends on the capabilities of the DCC hardware you are using. Some can be queried, while some cannot. Some which can be queried can report incorrect information. One "workaround" that you may

Dave and Peter: I moved the JMRI data into a folder that I created: Users/cgevaert/JMRI. When I installed the new version of JMRI, I moved the JMRI folder to the Applications folder. When I ran

Billybob, Thanks very much for the additional information.? I have some good ideas on what to look for at the museum on Thursday. I'll post what I find out to the group. Frank Fezzie

Martin, I have confirmed the behavior that you are seeing. I was also able to confirm with a set of Logixs that have worked for years. This statement has always been a part of the Logix help file:

Norb, It is one at a time. I normally do it as I set up each track segment. Change the track segment from a line to a circle; position the end points; hide the construction line. Dave Sand

Phil, The SE8C based signal masts will use the "Signal Head Controlled Mast" driver. The signal heads are defined using "SE8C 4 Aspect". When you are ready to replace a visual mast with a layout

So I made a sensor that turns on and off track power. However when I first load the panel, the status of track power is unknown. Is there a way to query track power status on startup of the panel?

Ok. ... so if I want to turn all of the construction lines off at the same time, I have to do so within the context menu of each track segment one at a time?? Is there a way to select all the track

Hi Ken Yes I have a Se8c and have physical signals that I am corporating into the layout. Can I use my exiting virtual Signal mast in combination with the signal heads? You mentioned that some Signal

Phil, Signal masts are generally better, but some find the logic gets a bit more complex. I think you said you had a Se8c, so you would have to make signals heads (using the turnout addresses) and

A quick search of the JMRI source code reveals that this specific message is displayed by LocoNet connections when JMRI is attempting to "acquire" control of a locomotive (or consisted set of locos).

That is my understanding of the code. I do not have a good handle on this particular bit of JMRI functionality, so I do not have a good answer. I _think_ that it will only happen when loading an XML

Thank you gentlemen So if I understand correctly I will need to change all my Signal Masts to Signal Head. The signal heads that I have created will change colour with the turnout and when there is a

Hi Dan, I also use JMRI WiThrottle to run my locomotives. I have also been able to connect the ProtoThrottle and TCS's new universal wifi throttle through WiThrottle to run TMCC locomotives. I use a