开云体育

Peter, I assume you are talking about Monterey. When you are running Monterey, can you open the xml file using TextEdit. The first couple of lines should look like the following: Maybe Dropbox is

I hope I get this working before you get tired of spoon feeding me!? I missed the double head selection,?? Thanks.

I can easily create turnouts, sensors and blocks but I can't delete them from their Panel Pro tables with jython. The only method I found while browsing the class structure was dispose() and that had

JMRI 5.10 on W11 I thought I would experiment with train tracking on a layout editor panel. I found that when the loco IDs are placed near a block that there is no indication that something has been

Hi All Would anyone be able to assist with this issue. History back ground I have been using windows 10 PC's ?for many years with no issues and dropbox to store the information. This has been

Steve, That's OK. Thank you very much. JeanLouisDelestre@... ----- Mail original ----- De: "Steve_G via groups.io" <RailRodder22@...> ?: [email protected]

Bob, thank you for your concise troubleshooting suggestions. Previously I had tried using DCS100 as a command station selection and it worked as expected. I started from the beginning last night to

Jean Build 2264 or later, found here https://builds.jmri.org/jenkins/job/development/job/packages/. As with all updates make sure you have a backup before installing. Steve

Steve, Is it this one ? JeanLouisDelestre@... ----- Mail original ----- De: "Steve_G via groups.io" <RailRodder22@...> ?: [email protected] Envoyé: Lundi 31 Mars

Hi Dan - thanks for info. Not sure what I did but when I built the 2 trains again the car pick ups are not duplicated! So, all good so far. I only have about 40 cars on my point-to-point layout and

I ended up using javascript to turn the room lights on when then webthrottle.html page is loaded by a user. The room light go off automatically is 10 minutes. long enough for a remote user to to have

If you’ve selected “LocoNet LocoBuffer-USB” and “DCS240+ (Advanced Command Station)” and you’ve still having _no_ communications at all, then I suspect that your settings are not the

Here are the choices I have in the Connections panel.? This is JMRI 5.4 but 5.10 shows the same panels.? This was captured on a Windows 10 machine and I know how to determine the correct serial port

I deleted the SML, set the block bi-directional and now Discover fails to find any mast pair. Since the logic behind SML isn't intuitively obvious to me I subsequently added a T7 trailing main mast

Thanks Dave. I originally did not have deniedBlocks and several SML failed. Since the layout is designed for only one direction I (painstakingly) right-clicked each block, edit block, edit routing,

If you set the block routes to bi-directional, the SML generates properly. Dave Sand

Signal masts require that you select a signal system. When you create a mast, you select the mast type such as single head or double head. To see the available signal systems, go to

I cannot get a single mast pair T7 to T2 via B7 to work as expected. T7 is a ghost block with a detection block pre and post. T1, T2 and T3 all share a detection block. B17 Shown below is a single

i have updated to the latest version of JMRI and see the ghost blocks. I set Masts for a Turnout that is now a ghost block by itself.? Now my problem is that I get only three signal heads.? One for

Dale, Sorry that I missed the crucial point in your OP and focused on our history of problems instead. With the computer connected to the LocoNet via the Locobuffer-NG, then "Locobuffer-NG" must