开云体育

oh my Silly Mistake,i have 2 Aiu of course mixed up the numbers.Apologies for wasting time Brett

Thanks Trevor. That might be what I'm looking for. JIm Little [email protected]> wrote:

Hi Jim, I don't have NCE equipment so this might not be what you're after, but I found this on the JMRI

Thankyou for expanation Inobu,will try today.Thats the step im missing.

Georgia, That sounds like an issue in the cab bus wiring. When you physically moved the AIU boards, you left them at the original addresses they had before? It might be worth rechecking the wires

just an update...? ?Ken from JMRI sent a firmware update the for NCE Power Pro.? I installed that and form some reason I can see one AIU in the cabs but not both. I've gone thru all the correct

I'm not accomplished enough yet with OpsPro to comment meaningfully, but it seems like a useful idea. CRZ

This is a great idea.? I would love to be able to control whether local moves are allowed for a location in a route.? Having this separate from pickups and setouts will work very well for

Fair points. What works for one doesn't necessarily work for others. My hope would be that, eventually, many responses to standard questions could be replaced with just a link to the applicable faq.

Hummmm. ?Gotta think about this. Jon in San Rafael

Bill, You should be seeing the id 7.3.7 in the logs. That says 'all systems' so JMRI lets that match any of the command stations. -Ken Cameron, Member JMRI Dev Team www.jmri.org

Yes, first and third were PowerCab and middle was SB5. All same profile, just changed the preferences. I put the jumpers back on the board, set it to 19,200 and it appears to be happier now.

Bill, I see three startups in the file. The first and third seem to be fine, but the second one has the problem. What was the settings in the connection for each of the three? To me, it looks like

No, sticky isn't "all very well for people using the group's web interface." That's exactly the problem - When you use the Web interface, the first page is stickies you have to scroll through to get

Here you go Ken, everything from today. I will re-install the jumpers and tweak the Advanced settings to 19,200 vs 9,600 baud. Bill Sent: Sunday, March 09, 2025 10:30 AM To:

Bill, That log didn't have the other run. The session.log gets reset every time you open JMRI. The messages.log is the last ### runs up a meg of file space. I think what would be best is a

Ken, There should be two sequences in there with the latter having it set for SB5 and resulting in the error. I have three throttles on the bus, my original power cab (with procan cable), a second

Brett, On Panel Editor it is straight forward. I used the SIM profile because I'm too lazy to pull my Power Pro out (I can if need be) First make sure that you can see your AIU and that its Cab

Looked at it and started to think about to do it, but I found that the SignalPilot has a lot of indexed CVs and, furthermore, there is no documentation about its CVs (all of them) :( , so,

Bill, This log looks normal. I don't see it showing any issue with opening the port, getting the id from the NCE USB. But what did you have set in the connection window at this time? I'm