开云体育

I did see that the schedule and mode are in the location export.? I'm confused, tho.? Are you saying that the same schedule could be assigned to Spur A in match mode, and Spur B in sequential

Hi Peter, Some questions after several hours of playing around ... 1. Re load - Does the indicator of 1.00 == no extra load? - Load indicator seems to positive and negative but I can't determine why

Eric, After starting PanelPro and loading the layout xml data file, go to the turnout table. What is the current state for the turnouts? Now do one click and see if anything changed in the turnout

In the transit definition there are transit section actions for each section in a transit. One of? the available? triggers is "on stop". So on stop set estop. Steve G.

That makes sense, Mike. Thanks for explaining that. However, I can confirm everything is always written on the mainline correctly as I do sound volume changes and speed matching and have yet to have

When you write on the main there is no feedback checking the writing so it will not cause an error if it fails to write as command station doesn't know. Mike

So I uninstalled 5.10 and installed 4.26, and had no problem in importing my decoder file and all worked fine. Any thoughts why had issues with 5.10? Roger, did you try to update directly from

Peter, Robin & James, To end my input into this message thread, after watching Peter’s YT videos on their setup, I today found the simple BT joystick gamepads I purchased probably 5-6 years ago,

I don't know if this will sow any seeds, Peter, but in the days of Loksound v3.5 I was fudging a working brake by using a combination of the Acceleration/Brake time and Shunting Mode to simulate

Jean Louis, The last selection at the bottom of the block table is retained in the user-interface.xml file within the profile directory. Dave Sand

Thanks, Steve. but pardon my ignorance but where do I specify the action to use estop instead of plain stop? Is it done in the transit table? -- +=============================== |. *Vimal

Isaac, Upload the messages.log file to the group's ProblemsBeingWorkedOn file folder. It will be located in the "C:\Users\<username>\JMRI\log directory. Dave Sand

I know. I was just giving the some possible good news Phil G

I've now tried hooking up the USB connection in addition to the Ethernet connection and I'm getting the same results. My first question is, is there a way to change the timeout setting, so it doesn't

In addition to a joystick, the small (finger ring style) Bluetooth game pad controllers I use with EngineDriver have 6 buttons that are all configurable in ED. I set one of the two front buttons to

Did you follow the procedure in the JMRI release notes on how to do the update? Once the update is done you shouldn't need to import anything. [email protected]> wrote:

Hi, I am new to the group but I have been using DecoderPro for years in my Windows (now 10) setup. I decided to update to version 5.10 and also downloaded the Azul java 17. All installed fine and it

Phil, That's the one you want to be running right now. It's the recommended version. [email protected]> wrote:

Bump

Response from the manafacturer. Hi Howard, I assume that the decoder drive you purchased was the 4L-001-001 (or the TrainTech SC3)? Forgetting JMRI for the moment, once the decoder drive is set up,