开云体育

For more info on adding a route and the locations see: ( https://www.jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#AddRoute

I'm looking for suggestions as to how to troubleshoot a failure of a WiFi Throttle to communicate with an NCE PowerStation command station. Information behind the problem: * TCS Throttle can connect

Doug, Do you get this window after you've hit the "Add Route" button in the "Routes" window? The next step is to select the departure location for the route added, then the next location using the

I am brand new to OpsPro and have run into a snag.? I want to start very small and minimize the screw-ups if possible.? I have managed to successfully make it through SETTINGS, LOCATIONS, CARS and

Mac sequioa is 15.0.1 Jim

Where do you expect car ACFX 72089 to go?? If Dunn Papermill, the setting for inbound cars from staging is set at 100% which means that only one car (44 feet of track space) from staging is

On my panel all turnouts are within a block, not their own block. The thru and diverging tracks from the turnout become separate blocks although in some cases I have simply continued the 'mainline'

Hello again, I got one set of build fails cleared and am now onto this issue. ?I have attached a build report for your reading pleasure :) it seems that the program is not using off spots for extra

Hello ALL! So I was able to find and correct problem of previous build fail. now onto another build fail issue. I will start a new topic. “Build fails…not using off spots or holding

Thank you for your help. ?Following this advice on aINTEL IMAC machine running Sonoma 14.6.1 ?I found problems with the ports. I hooked up a new. Apple M3 running Sequoia 10.0.1 and everything is

John, Q1: I change the global turnout speed for thrown. I don't see an issue with adding your enhanced signal system to JMRI as long as it provides consistent aspects using the default turnout

I did a trick with the multi-sensor for a vertical storage track system. It had 4 icons, one each for the three different alignments and the fourth was 'Moving' in a flashing icon. When the turn

I have uploaded my file. In an effort to setup a new engine, I some how messed up my connections. I created a new connection for my Power Cab, which is only used for programming on a program track.

Dave Sand: ?Thank you for the response and very helpful information. ?After digesting your suggestions I now better understand the influence of speed in "our Aspect" selection. ?They also prompted

When a train is a turn, the train's name doesn't change even if the lead loco is swapped at the end of the branch.? Not sure why you would need the consist name to change, you don't need to show it

You can start here: https://www.jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#BuildlocoConsist Dan

I'm not far enough along on my layout to test this yet, so I'm just trying to figure out how I'll eventually handle this scenario. I'd like to configure a train to: * Start on the departure track in

Thanks for the answers to the questions.? I will probably use multiple icons overlayed on each other to show the turntable in different positions. I have used the multi-sensor icons for the

Hi and thanks for your answer. I recently discovered this article, but there is no visual example, particularly on the path function. It's not easy. For example. Do you have to include a

John, I downloaded the file that you uploaded and it runs fine. Since I am using a simulated LocoNet connection, the turnouts and sensor work fine. The LocoNet simulator has an option to set all