开云体育

Hi Versions of JMRI greater the 5.8,? (currently test releases 5.9.x ) give much greater detail when running install test or using the /noisy parameter so there is less guessing why jmri startup

Hi all… The good news is that I seem to have resolved my problem. Further to the ‘InstallTest’ report, I uninstalled Azul zulu17.50.19-ca-jre17.0.11-win_x64 and replaced it with Azul

I subsequently ran the JMRI 'Install Test' with the following report: Testing for Java working <JAVA_HOME>/lib/ext exists, extensions mechanism no longer supported; Use -classpath instead. .Error:

Hi all. Alas, I need some guidance here! I've just gone through the romance of reinstalling Windows and have been religiously reinstalling my various apps. I reinstalled Java Azul

I rely on the info I get from a Class I railroad's "Chief Signal Engineer". Hopefully I have written in my "signaling" messages a reasonable interpretation of what I have heard from him... Regards,

I've been using Bob Bucklew's 3-part tutorial as my way of leaning PanelPro, and in his example, he used holding signals at Interlocks on his Quaker State layout., as I'm still learning about signals

I have not been paying close attention to this thread, so I ask, "What JMRI version are you using?" I have a _vague_ recollection that some older JMRI Versions did not behave the way that current JMRI

Derek, Does the sensor shows up if you restart JMRI? Are you sure that the sensor isn't used anywhere else, for another turnout? Daniel

Okay, in next test release. Dan

Ron, XML entities can have two forms: <perform ....> .... </perform> or <perform .... /> It's the latter form that's used on the second "<perform...>" in Gil's example. So it's correct. Daniel

And of course as I am trying to write up a reply (which involves some careful thought and time), the problem becomes moot! ;-) Pete

Did you actually have two Spurs using the same schedule for the MTY refer? And on each of them, you left the "Destination" column blank? How did you get this refer into the Spur and it remain MTY??

I’m no xml or JMRI expert, but is the second “<perform…>” clause missing a corresponding “</perform>” ? Feel free to disregard this if it’s completely wrong. Just my 2c worth, which,

Hi Daniel, JMRI is showing my layout control panel when I am using the Sensor table and Turnout table to try to configure the sensor to the turnout. Derek.

Hi again Dave, I am trying to assign the sensor to the turnout as a feedback sensor, as I have done dozens of times in the past. The list does not include the existing sensor in the sensor table. I do

Dan, After preparing the build report for attachment to my reply, I re-read the section relating to the car and found why the system was deleting the final destination - the car length is longer than

It is my interpretation that setting an "intermediate" signal to "held" is really "not a thing" in JMRI signaling. That is because a "prototype" intermedate signal shows a signal's most-restrictive

Derek, Are you assigning the sensor to the turnout as a feedback sensor? What are the sensor names (system and user). Are there any messages in the system console? Dave Sand

Gil, Try to restart the computer between the tries. Daniel

Derek, Do you use Layout Editor, Panel Editor or Control Panel Editor when you do this? Daniel