开云体育

I have not been paying close attention to this thread, so I ask, "What JMRI version are you using?" I have a _vague_ recollection that some older JMRI Versions did not behave the way that current JMRI

Derek, Does the sensor shows up if you restart JMRI? Are you sure that the sensor isn't used anywhere else, for another turnout? Daniel

Okay, in next test release. Dan

Ron, XML entities can have two forms: <perform ....> .... </perform> or <perform .... /> It's the latter form that's used on the second "<perform...>" in Gil's example. So it's correct. Daniel

And of course as I am trying to write up a reply (which involves some careful thought and time), the problem becomes moot! ;-) Pete

Did you actually have two Spurs using the same schedule for the MTY refer? And on each of them, you left the "Destination" column blank? How did you get this refer into the Spur and it remain MTY??

I’m no xml or JMRI expert, but is the second “<perform…>” clause missing a corresponding “</perform>” ? Feel free to disregard this if it’s completely wrong. Just my 2c worth, which,

Hi Daniel, JMRI is showing my layout control panel when I am using the Sensor table and Turnout table to try to configure the sensor to the turnout. Derek.

Hi again Dave, I am trying to assign the sensor to the turnout as a feedback sensor, as I have done dozens of times in the past. The list does not include the existing sensor in the sensor table. I do

Dan, After preparing the build report for attachment to my reply, I re-read the section relating to the car and found why the system was deleting the final destination - the car length is longer than

It is my interpretation that setting an "intermediate" signal to "held" is really "not a thing" in JMRI signaling. That is because a "prototype" intermedate signal shows a signal's most-restrictive

Derek, Are you assigning the sensor to the turnout as a feedback sensor? What are the sensor names (system and user). Are there any messages in the system console? Dave Sand

Gil, Try to restart the computer between the tries. Daniel

Derek, Do you use Layout Editor, Panel Editor or Control Panel Editor when you do this? Daniel

Making progress on our club's N scale layout CTC panel. I'm currently setting up the signal logic. I have one signal logic finished with finally getting the OS (Interlock) signal hold logic figured

Further, I went ahead and killed the task as well as Java. I disabled starting the web server (so back to the configuration of a single action active, automatically load the panel file). Restarted and

Sorry, I was a bit too quick to declare success. After changing look and feel to Metal and disabling the action to manually load the panel file - JMRI started fine with only "automated file load"

Is there a way of updating the dropdown list of sensors to match the sensor table? I have created a sensor in the sensor table and wish to assign it to a certain turnout. However, when I go to assign

Daniel - yes that did the trick. It loads fine with Metal. Thanks! any explanation why this is happening?

Thanks Bob. Needed to drop the NT23 from the getKnownState brackets and it works. The state is 2 for closed and 4 for thrown. Many thanks. Derek.