开云体育

Forgot to add. WiThrottle is currently quitting at f28. Personally I only need up to f31 though, not the full works (yet) - this is the highest I see in my LokSound 5s…. Phil G

Well, it goes from f0 to f31, so that’s 32 functions. Let me dig around a bit

As Wouter pointed out, this topic has strayed way past anything to do with JMRI. Further discussion on wiring, resister wheelsets, etc need to be taken elsewhere. -- Peter Ulvestad JMRI Users Group

John, I did a test with your logic and it works. Are there any message in the JMRI system console? Does the NX work properly when clicking on the NX sensors? Maybe you have a conflicting route

Slight correction on resistance: Special case, when all resistors are equal. Otherwise, use the formula for parallel resistors (R1xR2)/(R1+R2) reiteratively:: The second wheelset with resistor halves

Dave, Thanks again for your reply. Yes you are correct according to what I posted except I made a mistake in the post - sorry about that, what I really had and still have is this: ! A? If Then

can we use locos with this new 5.2 version in our trains?? If so, is there a link for instructions?

Thanks, but I have one of those, I'd like one that has more than 32. This thread led me to believe they existed, maybe they don't (yet). --SteveT

Yes, JMRI doesn't require anything off the internet while installing. -- Peter Ulvestad JMRI Users Group Moderator ( https://www.jmri.org ) Tam Valley Group Moderator ( https://tamvalleydepot.com/

Ohhhh. I misread your question I’ll send you a roster entry later. From a LokSound 5 that goes at least as far as f31. Would that help? Phil G

Layout location has no internet connection. Can JMRI be upgraded with the executables off line? Thank you Allan Stony Plain Museum

I'm not sure where any of the code is as far as getting to production. That's why I'm asking for an example, so I can test. And thanks go to Brett Hoffman for the JMRI changes.

Just a note from a guy who took a 28 block DC layout to a 48 block DCC? layout by isolating the turnouts.? For single turnouts, place a signal at least 40 scale feet from the points end of the

I’ll look at this tonight. Do I need an updated WiThrottle? Oh, and THANKS Phil G

John, A2 is toggling the state of the NX. Since it is active based on the if, the new state will be inactive. The Return statements are not needed, return is automatic. Dave Sand

Good morning Bob, Any news? I know that to perform this Nuclear Reset (AKA USER PRESET 1 RESET) CV201, CV202, CV203, and CV204 must be written in order with the appropriate values. Would you expect

All, Changes have been made in JMRI WiThrottle Server, WiThrottle and EngineDriver to (hopefully) handle the higher functions (or at least quietly ignore them). Can anyone share a Roster Entry or two

Thank you for the solution to my issue described above. OK I have updated to version 5.3.5 and the issue has gone away. Now I want to set a pair active using the following logixNG I have: ! A? If

I am running version 5.2 Production Release. So you say I need to use a a "Test" Release? That seems strange but I will try it.

Steve, Jerry's sketch works, but he made custom changes to the MFRC522.cpp. I haven't looked into his changes in-depth, but they should also work on the 8266. I will let him elaborate. The good news