开云体育

Peter, Does any of thus carry over to CV writing and reading with PowerCab system. I use my PowerCab for only Program Track and the Pro system in the layout Dave In PA Sent from iPhone Xs Max

Here is a copy and paste from a post by Dave Heap Power Pro CV Limitations ================== Due to a firmware issue, the NCE Power Pro is: - Capable of reading values correctly from any CV in the

2020-02-06 18:58:21,302 util.Log4JUtil? ? ? ? ? ? ? ? ? ? ? ? INFO? - * JMRI log ** [main] 2020-02-06 18:58:21,319 util.Log4JUtil? ? ? ? ? ? ? ? ? ? ? ? INFO? -

Cliff I just uploaded files to the FILES BEING WORKED ON folder (subfolder RJE).? It is a large zip file - about 5 MB so I'm worried I might be hogging too much of the upload files space.? Let me

This may be an issue with your command station and extended CVs. Check out this thread: /g/jmriusers/message/145419 -- Peter Ulvestad JMRI Users Group Moderator - https://www.jmri.org

Are your using a programming track booster? Sent: Thursday, February 6, 2020 2:51 PM To: [email protected] Subject: [jmriusers] Econami and Tsunami2 Programming issue I have run into a very specific

I would suggest you provide the System Console log when the issue occurs? as a start.. That or the Messages.log HELP > System Console? >? Copy to clipboard? > Paste it to this thread. Marc

Thanks Dan Mike

Cliff Once again thanks for your help!!! I do keep the custom icons outside of the JMRI programs folder on my c: drive – I actually have set up a cloud drive on our Synology NAS (J:). Maybe we are

I asked Soundtrax a similar question about a used Walthers P2K engine, and received the following prompt and helpful reply: These decoders are based off of the original Tsunami decoder. I've included

Rodney, I think I see what the issue is. Thanks Clay

Bob, After a lot of interruptions a block of time allowed me to investigate at least some of what you have described. Unfortunately, I am not able to duplicate what you are describing with your icons.

Mike, I was able to fix your issue.? Mike had a local switcher that departed staging, serviced a location, and returned to staging.? The program didn't handle the staging track correctly for a local

Rodney, here it is. 2020-02-06 13:41:35,541 util.Log4JUtil??????????????????????? INFO? - * JMRI log ** [main] 2020-02-06 13:41:35,619

I have run into a very specific programming issue with Econami and Tsunami2 decoders: NCE PowerhousePro JMRI 4.17 or 4.19 (upgraded after I first had this issue. It did not have an effect) I cannot

I have a 25' RS232/serial port pass-through cable between my PowerhousePro and my USB adapter. It works without issue. Micheal Farley Bismarck, ND www.facebook.com/yellowstonedivision

...meanwhile the GP35 profile worked just fine for now...

Marc, He sent me same - so next step for me is to wait for the appropriate file to appear at: https://www.jmri.org/xml/decoders/ ? -Dan

Cliff and Marc: ?Thanks for the replies. ?Still no luck. I found COM 3. ?Opening the program's preferences now shows conn. EASYDCC via serial on COM 3. EASYDCC command station states: "controlled

Dear Marc, Yes they are in a consist. Broadway Limited units are 2 A units, Digitrax are 3 units, 2 FP7As and 1 F7B. Both these consists are run with all the units in the consist set to the same