开云体育

Rodney, here it is. 2020-02-06 13:41:35,541 util.Log4JUtil??????????????????????? INFO? - * JMRI log ** [main] 2020-02-06 13:41:35,619

I have run into a very specific programming issue with Econami and Tsunami2 decoders: NCE PowerhousePro JMRI 4.17 or 4.19 (upgraded after I first had this issue. It did not have an effect) I cannot

I have a 25' RS232/serial port pass-through cable between my PowerhousePro and my USB adapter. It works without issue. Micheal Farley Bismarck, ND www.facebook.com/yellowstonedivision

...meanwhile the GP35 profile worked just fine for now...

Marc, He sent me same - so next step for me is to wait for the appropriate file to appear at: https://www.jmri.org/xml/decoders/ ? -Dan

Cliff and Marc: ?Thanks for the replies. ?Still no luck. I found COM 3. ?Opening the program's preferences now shows conn. EASYDCC via serial on COM 3. EASYDCC command station states: "controlled

Dear Marc, Yes they are in a consist. Broadway Limited units are 2 A units, Digitrax are 3 units, 2 FP7As and 1 F7B. Both these consists are run with all the units in the consist set to the same

Did same and got word from Josh levine? that they are putting the info together to update the Factory Installed Decoder listing for Walthers. He sent me a .doc file for the New York Central , a

You must write the selections out to decoder? via one of the four " WRITE " options or the changes you make will have no effect on decoder. If you try and close DecoderPro or the open? Roster

Just spoke with a helpful person at Soundtraxx.? He has to dig around a little bit as the CV info didn't readily appear to him, so I am awaiting his follow up.

I should also mention we operate every month and all of us over the course of a year have to travel 3 hours at least once so our sessions range from 2 hours when we are showing off our new toys up to

Hello, If I change a CV value from the CV tab in DecoderPro does it change the function mapping automatically if it was affected by the CV change? Thanks, Dick M.

Question, Does the Dispatcher perform the duties of the Clerk or is the Clerk a separate job on your railroads? If the Dispatcher does the Clerks job they already have all the info needed. If the

Hi. I just did a speed matching on two BLI E units, an A and B set in HO. Are you using JMRI to program? If you do you should use the speedtable. In the speed table you can adjust the individual

JMRI test version 4.19.2 NCE simulated or connected CMRI simulated or connected Win 10 or Win 7 Java 1.8.0_241 (en) I built my original layout editor panels and have been using them to control my

Dennis, if you are only looking for the originally planned train consists and time o

Update: I have pushed possible fixes for both of these, available in the Development version here: https://builds.jmri.org/jenkins/job/development/job/packages/ Dave, I would appreciate it if you

Thanks to all the responses so far. Likely going to go with the GP35 as it is my understanding that the Walthers Tsunamis may have slightly different programming features than the non-OEM decoders.

Starting with 4.19.2 (it wasn't a problem in 4.19.1), I can't see the bottom of my panels, and I can't zoom out, nor scroll down. This is also present in current code (as of 8:15 AM, EST). The

Hi Gang, I am reconfiguring my layout room and will now have a dedicated space on a desk for my laptop. Problem is that it is about 25 feet away from my NCE Powerhouse system. When I started with JMRI