开云体育

Guys, came up with another problem today. Tried to modify the speed table on an ESU lokpilot V4, however, in decoder pro i?m not able to change the first an last column of the speed table, since

Frank, What about a WiFi extender? I have one on order to work with all my Ring and garage door openers. David Klemm Sent from my iPhone 11 PRO Max ________________________________ Sent: Sunday,

Fred, I've never tried to use the same throttle object for a different loco. I'd get a new throttle object. -Ken Cameron, Member JMRI Dev

Thanks Bob Bucklew!? I agree with Inobu and love your tutorials! And thanks Ken!? Love this conversation!? Every response is exciting and makes me think about this more.? As I said before, so

Thanks guys for your info.? Unfortunately I'm more confused. To clarify a little more I'll go off of Billybob's message. - JMRI shows the turnout table AND the sensor table with no data when I open

Thank you Ken, Dave, Perry, Cliff and Inobu! Ok, here is the culmination of my frustrating experience... Finally, I was able to get the USB cable to work.? Oddly, in another port on the laptop.?

Fred, I have two separate scripts running to control two locos on the same single track mainline with a passing siding for them to meet. An internal sensor set by Logix when they meet permits each

Steve I have discovered a problem with dispatcher. I have a LH crossover. When the dispatcher routes go across the bottom or top the dispatch works ok, but when the route goes from the top rails to

In addition to Marc’s points, could you check the JMRI log for warning or error messages? It’s at Help -> Console Bob

It may help to see the script. Basically, the IDTags SHOULD be loading the first time the IDTag manager is asked for a tag. ( they don’t automatically load because you may not need them for every

Does the Windows Device Manager recognized COM2 as the " R8214 Hornby Elite (com2)? ". Or simply some serial device on COM2 ? What if you disconnect the USB cable between the Elite and computer, does

Which version of JMRI are you using? If you go into your preferences and the Defaults tab are they set for internal or your command station? How are the turnouts defined in the turnout table? --

Can you operate the snap switches with your throttle? Did you check you power supply voltage? I use the DR4018 using the atlas snap switches and work well with JMRI. Dennis Owner/moderator:

Hi there - I'm struggling to get decoder pro to talk properly to my Hornby Elite. What happens is this:- I Invoke decoder pro, new loco, then click the button to read the type from decoder - all I

Hi all, Outside of back dating my computer to change the date on the header block on the print out. Is there a setting to change it? Mike

I started with the back and forth timed script and have been able to get it running just once. I’ve added turnout control and run function keys for light, horn, bell. All under timer control. It

I installed a DR4018 from Digikeijs on my layout to control my existing snap switch on my new dcc layout. I was very happy when it worked first time using my MCR Prodigy Advanced. But it does work

And that's all I was trying to do. I don't have JMRI, but from what David was asking, seemed like a simple thing to me. If JMRI can bypass Bachmann/Soundtraxx proprietary system, fine. But my solution

Frank, Just from looking at your layout earlier i could see the potential trouble hence the comment about two dispatch positions. That layout has a need for two dispatch locations. One local and the

Frank and Dick, I think Dick's explanation is the most likely. Given the length of the cable, it's likely the USB interface part of the Locobuffer II USB is drawing enough current through that long