开云体育

I was browsing the JMRI DecoderIndex.xml and it has? HAG Modelleisenbanh AG as Manufacturer ID 81.. NMRA? Manufacturer ID? dated 2019 shows it to be 82. That is more or less important as there are

I agree that would be very helpful. The current ‘single key sort’ is not always adequate.

Kirk, try updating to 4.16 (or wait approx. five weeks and try 4.18). There have been quite a few improvements to Loconet throttle handling / stealing since 4.14 (most already from 4.12 to 4.14, but

Jim, I have both Cab1L and Cab2L on my bench and know how the programming works. You will continue to argue that it works until you get a Cab2L system. Then you will see that it works "Better" when

I have what I consider a medium-sized, primarily switching focused layout (about 14'x15' plus 2 6-track staging yards in another room) with about 10 trains on the schedule. In my case, as a lone wolf,

Bill, Thanks. Rick.

You might have an older MRC decoder. Those cannot be read at all (Not enabled in hardware). Read gives random numbers. Might need to open the Lok and send a photo of the insides. (Or install a newer

Jan, Thanks. I will check that out. Rick.

Hi Steve I've just had a quick look a look at release #3519 and those changes look really promising. I won't be able to test properly until tomorrow (at an exhibition), but it looks like they display

Jim You are aware that by clicking the column header you can already do this? Mick ________________________________ Mick Moignard m: +44 7774 652504 Skype: mickmoignard Sent from my iPad, so

Hello. If we have a decoder not defined by Decider Pro can you still download the values in the cv’ s from a new locomotive? ?In that way keep the original settings for future use? ?If so, please

I have several Legacy engines and a crane car. They all work just fine with my CAB 1 and bas and JMRI. Obvioulsy they do not allow all of the new functions to work but they run and stop and coupler

Gary, Their setup is working as TMCC-1 not TMCC-2 . TMCC-2 is Legacy and it will not work. The Legacy Base is backward compatible to TMCC-1 therefore it will send TMCC1 commands over the port and it

I have been meaning to get a legacy base for a long time. Ordered one yesterday. Will test this myself. Seems to be a lot of conflicting info out there on what does and does not work. Since I was the

Gary, I am using the Legacy base as well.? You would assume the serial connection would be the same.? Looks like Jim has knowledge otherwise.? Have you tried to post your question on the OGR

It was all working in Nscale to set the throttle and run trains, etc, on the Raspberry Pi 3B, but when I moved it to HO, it’s failing to get the throttle. I’ve done some research and there’s

Randall: Not working for me on either my Pi 3B+/Raspbian Stretch or a PC running Mint 19.2 Cinnamon. Could this be an OS issue? I'll try a Pi4 and Buster later... Open the WiThrottle server and

Nick, FWIW, I've never found a working way to have multiple files for the panels. I only have one panel like file for a layout. The issue Dave pointed to about the SYS group of Logix is one example

Marc, Thanks for the reply. I don't know enough about DCC to answer your question other than to say that I am using a NCE Powercab system and it reported the Mfg. number and JMRI was unable to find it

JMRI saves window locations and sizes (and most other preferences) only when it is allowed to exit nicely--this avoids having JMRI constantly write changes, which may be undesirable on slower media