开云体育

Not entirely sure what you’re asking, so if this isn’t the right answer, please ask again. Once you’ve created a head or mast, it’s created. You can’t change its type. In this respect if’s

Peter, I am not sure what you are talking about. I assume the toggle switches are on the layout and that they are used to drive the turnouts. I don’t see any toggles on the panel. If so, JMRI will

John, that isn't my problem, sorry, I wasn't quite clear.? I have a single 700 series engine grouped with the 500s, when it should be the first of the 700s.? ?Each of the numerical columns are

Hello. I am creating signal head and see that when you create one, you get to specify a few pieces of information that apparently you can't then view once the head is created: the " *connection type*

Mitch, Your layout plan has two reverse loops and what is effectively a double crossover at 6/8. It appears that these characteristics are causing issues with block routing. The automatic signal mast

Hal, The Layout Editor grid is drawn to be a bit larger than the furthest right and lowest objects on the panel. If you add another turnout to the right of the first one, the grid will adjust. I

I'm trying to build a new layout in LE, nd right off the bat run into this weird problem: in a new Layout, I add a turnout. Then I move it (left-click, drag) and the layout surface truncates to a

Hi Paul, Great news you got it working. To your issue with Build Failures, remember you can always put virtual staging tracks at each end of your JMRI Ops railroad to give all the cars enough space to

By the way, Breezly. That setting was shown in the build report so you were right, the problem was identified there. Thanks, Everyone Paul

Looks like I found the problem! In train build options, "allow cars to travel from origin to terminal" was checked. By unchecking that the switch list gave me orders to swap an empty for a loaded

Off the top of my head is font changeable on manifest as to size of type it may just be the matter of a couple of points causing the issue.

Hello. I use an Epson Work force WF 3720 ink jet and the PDF prints just fine. But the manifest is one line to large and the bottom line is a one/half line as if the bottom half of that one line is

Breezly, I just built a train from a staging track which contained one loaded flatcar. There is an empty flatcar on the spur in question now. I would expect the switch list would have me pick up the

All, Was moving my updated JMRI layout file from my notebook over to my raspberry pi and noticed after bootup that the block values were missing.? So I assumed that there must be some other file

Charley, The top of each column can be clicked on to arrange that column in either ascending or descending order. Each click will reverse the order. [email protected]> wrote: -- John Griffin

Breezly seems to think the answer may be in the build report. I am not familiar with these as a beginner but I will look into it and see it there is something in it that helps me find out what's going

Thanks, Dennis. I have already checked that, in fact I added length to the spur to be safe :-) It did not help. Thanks Paul

Thanks for the reply, Bob. While I do appreciate the help you are the third person to tell me to set the move count to 4. If you read my second post you will see that no scenario calls for more than 2

My Roster has some locos out of numerical sequence.? Using? Win 10, Lenz LZV100, LH100, LI-USB.? How can I correct that? Charley Goddard Muncie, IN

What brand and model of printer do you use? Laser, ink jet or antique dot matrix?