开云体育

Thanks for the reply, Bob. While I do appreciate the help you are the third person to tell me to set the move count to 4. If you read my second post you will see that no scenario calls for more than 2

My Roster has some locos out of numerical sequence.? Using? Win 10, Lenz LZV100, LH100, LI-USB.? How can I correct that? Charley Goddard Muncie, IN

What brand and model of printer do you use? Laser, ink jet or antique dot matrix?

As a work around print the P D F and see if it prints on printer ok.

Hello Paul, JMRI Operations adds 4 feet to the length of each car to account for the couplers.? Make sure the spur length is long enough to hold both cars.? Hope this helps. Cheers, Dennis Drury

What you want to do requires the location/spur to allow 4 moves. The act of dropping a car is a move the act of picking up a car is one move so it takes 2 moves to drop and pick up a car 2 cars = 4

Frank I use three printers during a session. All my paperwork is Excel generated so I use the "fast draft" setting as to print quality. However, if I forget and do not change that to normal when

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* Test Bed Dale Trial.xml *Uploaded By:*

Hi Dave. Many thanks for your help re editing connections. Got the hang of it now and started to create a panel including part of the layout. I have used MERG parts only and entered these as hardware

This sounds like the printer has a problem printing close to the ends of the page. This is common with older laser printers where the printer cannot control the ends of the sheet to maintain contact

Hi. Yes the PDF printed fine so I guess it is a printer issue. I just wonder why the results would be different? Interesting. I cannot find any setting on the printer to ?do something that can

Mark asked: "Has anyone used the Configure Command Station tool on a DCS240 and discovered it did not work ?" While I have used the tool with a DCS240 on a number of occasions, it has worked without

Cliff wrote: "What can be clearly observed is that the status reports for some OpSw values cannot be depended upon to be correctly reported. From here, my only record of the questionable status is

Thanks, Breezly I will look into this today and let you know how I made out. However, the program is moving both cars, from staging to staging or to a yard. It's just not giving me the two moves at

Don OK good to know. Today (Sunday) my layout was on a Layout Tour with 11 other layouts. 10.00 am to 4.00 pm - now it is over. I had a problem with my phone - unable to drive a train, it showed on

Mark, The Purge time setting was an attempt to sidestep what we now believe to be a repair problem with the DCS200 on our workbench. We now know that some conversation with the Digitrax repair

okay so.. When I do the delete paths routine, save, reload, and generate signal pairs.. the S01 to S08 path works, SML shows the blocks used etc. I save the file, close JMRI, re-load and then check,

That worked a treat! Thank you! The issue with crashing trying to change the section stopping sensor is still persistant, though. -- Thanks Mitch

Paul, Set the build report option to "Very Detailed" (Info available here: https://www.jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#BuildReportDetails ). Then build the train.

Mitch, I was able to get the SML from S01 to S08 to work. If you have been making a lot of block changes, the block routing can get confused. The unique double crossover at LT2-3-4-5 and its blocks