开云体育

Hi Tim, I have tested your panel file using a?simulated Loconet connection and simulated OpenLCB connection. These simulated connections are to represent a layout connection when you've got no

We are running JMRI V 4.17.4 and Digitrax DCS 240. Closing OpSw 36 with JMRI has no effect on the command station. To clear all slots we must use the loco reset button on the DCS 240. Is there any

Mitch, Delete the section the sensor is working with then try to delete the sensor.? I've seen a few cases during recent JMRI versions where the programmers would not let you delete an item until

Any ideas, anyone? -- Thanks Mitch

Thomas, Any progress on this? --SteveT

The 4 new points I installed only work when My Layout is in edit mode. Any idea what I have done wrong? Thanks for all your help. PanelPro 4.16 RasPi Java 1.8.0-65 Switch 8 to Tortoise motors Insufrog

You may recall I have been unable to control old Lenz LE103 decoders with JMRI throttles, although I can control newer basic NCE decoders and SoundTraxx Econami steam decoders, at least the one of

"Haltz" (or whatever "friendly name" you would prefer), Setting up JMRI "signal mast logic" _does not require_ that you modify any "Signal Mast Appearance definition file" if you are using one of

Hi Jeff You said the USB to Serial cable worked in your mate’s computer, that confirms the Cable is okay. From your Console Log, it shows COM 3. Make sure you are using the SAME USB Port on your

Is your Mac editor "TextEdit"? If so, try pressing Command F.

Jeff, One trick is to confirm if the serial out to the command station is working. The trick is you need to look real close at the 9 pin connector and then jumper pins 2 to 3. If you do this, then

Jeff, I was going to direct email you, but realized that it's better having all these wonderful folks see my response - just in case I'm too far off base!? We discovered recently that there are some

Is the editor the same one that you used previously?? Maybe something on your computer changed, so that you're using a different editor. Dan

Sorry...yes...I get the preview...then text editor...then I can scroll down the build report...but I cannot find the "FIND" option which normally appears at the top of the build report...THANK

Hi Dan....Just to clarify....YES....It is the first line of the options and it is checked. ?I did not confuse it with the option to print the manifest in text editor format on the main settings

I don't understand your answer. But if you have the "Use text editor to preview build reports" selected, that should bring up your computers text editor when previewing the build report for a train.?

Hi Dan.....YES....It gives me the manifest but not the "FIND" in the build report....THANK YOU....Frank in Houston..

Frank, In the Build Report Options window, do you have the option to use an editor selected? Dan

Hello. I am trying to learn how to set up Signal Mast logic. The JMRI documentation "JMRI: Signal Mast Logic" is pretty good but has me stumped when it talks about the?Signal Mast Appearance

Ok...I updated the driver for the adapter, but my computer didn't like that and Device Manager kept refreshing about every 10 seconds or so. When I had a bad adapter several years ago, it did the same