开云体育

I have tried to set up some NX routing, but have found that JMRI crashes after I click the first NX sensor. I know NX routing works because I saw it demonstrated successfully at a cource run by Pete

I have found YATT very useful, and have used it in my club to move a train around a timesaver puzzle. Thanks Dave Sands very much. I found that I needed two enhancements in order to reduce the size of

This update worked, it read the decoder, i saw the engine lights flash and the link light on the MRC system flashing too. I also saw the traffic in the MRC monitor. It did not progress to the "next

Does the Intellibox have RailCom enabled ? If so, try with that turned off – my experience is that several Digitrax decoder types don’t like RailCom. I really doubt that there is a change to the

UPDATE I have fixed this. The reason was a large number of spaces was slipped in the start of the messages destroying the formatting stc. I cleared these and now I can read the HELP file properly.

Thanks for your swift reply Dave. Point taken regarding the number of variations on the market. I still have a problem of viewing the HELP info below the layout. I am using a Surface GO laptop in

One other little gremlin I have noticed when using Monitoring, is that an external poll of the switch status may cause an incorrect state to be displayed on a Layout Editor Panel for turnouts marked

Dave, If I may, I would comment that the ability to create a Double Crossover using 4 turnouts and a Diamond Crossing would be a great help as would the ability to have a smooth transition/join

Hi Dave Sorry for the delay in replying. Was away yesterday. I have set up as you suggested and what I am finding is the HELP info below the layout display appears to be greater width than the main

Conrad, A left mouse click above the slider handle should increase the speed by one speed step, a click below should decrease the speed by one speed step. You can save your throttle layout, see the

Hi all, I (and others) have this issue with various digitrax decoders. (DH123D, DH126D, DH166MT, DH126MT, DH165LO, DN136D, DZ146PS) When running them on a uhlenbrock intellibox command station the

Please ?explain this new app and how I can get it. Perhaps it will solve my problem as well. I am referring to to the issues I raised a day or two ago about repeated loosing connection and

> > Hello recently when I want to edit the “build report” after building a > train, I can no longer find the “find” option which normally appears at > the top of the build report. This option

Right, that was the link that I went to, but it just wasn’t all sinking in. Your explanations were very helpful. Thomas Cain Indianapolis, IN atsf93@... See my NEW website and layout at:

There is a general definition already in JMRI for the Hornby TTS decoder. I used it to alter settings on my TTS fitted Hornby P2. There is no need for specific definition for the Britannia, the only

Klaus, I got JMRI throttle coasting to work.? Page down and left mouse/page down did not work.? BUT, I stumbled on right mouse, saw properties and a check box for "track slider in real time".? It

Thomas, No. However, any monitoring system increases traffic between JMRI and your Command Station. An alternative, the use of on-turnout sensors and AIUs not only increases cost, wiring complexity

Am 17.09.2019 um 18:32 schrieb conrad: 1) Have you tried the keyboard key "Page Down" twice? 2) If the throttle decreases to much, try a left-mouse-click beneath the slider handle followed by a "Page

Dave, That worked! Thanks, that additional functionality is so very much appreciated. I do not allow operators to use Hammerhead throttles in Op Sessions for the reason that I could not see their

I'm guessing I have a bad decoder, as the single CV reset did not work. Thanks for the help!