开云体育

Sorry if this a repeat issue. A few weeks ago I bought a wireless router to us just for the layout (no internet connection). I had been using the house WiFi but didn't feel like handing out my

Hello... YES, I am using the Digitrax DCS240 via a Locobuffer-USB and until recently everything was working beautifully. My router (for TV and everything) is in the same room as my computer (Apple) on

I just upgraded my Raspberry Pi3 and 3B+ to Buster from stretch. I had to re-do my whole Pi as the VNC wasn't working properly. I would strongly suggest a good backup of JMRI files, photo's and any

Mitch, Are there any messages in the JMRI console when the unexpected sensor behavior occurs? Dave Sand

Tim (Dave), I was away from the computer all day yesterday and I see that Dave has answered your question better than I could. Somehow your email vanished from my in box when i was writing my reply. I

Frank, You still have not even said what DCC system that you are using. It could be something as simple as having two throttles dialed up at the same time. Dick :)

Are you trying to run both the DR5000 and the Lenz both as command stations on your layout? Dennis

Frank: As others are pointing out just how you're connected to your network will make a huge difference. You didn't move anything just went to 4.14.4... PC is WiFi itself or wired ethernet? If more

Jim - It most certainly is issues with the wifi. Instead of access points, you may want to try mesh extenders. Bob Robert Heroux ACCU-LITES, Inc. 12172 RT47 Suite 130 Huntley, IL 60142 Phone:

This sounds suspicously like wifi network problems. Maybee dropouts or weak signals. I have 3 wifi access points in my house and I have to make sure that I am connected to the one in the train room or

Tested with 4.16+R9f9aced current production release and issue is not present, worked instantly -- Thanks Mitch

Hey guys, I just noticed a random bug, I've had my layout working well for some time and started to do some experimentation with new transits and dispatcher. I went to fix an error i made a while ago

Sorry, in my first reply I forgot to mention that I stopped the “Malware” firewall during this attempt to run trains. Frank in Houston.

Good morning. Sorry about that. I am using a IMac computer and last night was finally able to connect to my railroad and run a train for a short distance. Now I loose connection after a few seconds

The next obvious question is: On what hardware is the original poster wishing to update firmware? As Marc points out, some Digitrax LocoNet-connected hardware (and some non-Digitrax hardware, too) can

Frank, Two preliminary questions: 1. Can you use the Tools >> Throttles >> New Throttle menu item to obtain a screen version of a throttle and then control a locomotive from that window? 2. Your

I just downloaded 4.17.4 and installed it. ?I them started the JMRI operations and attempted to use my android phone to run a train (same train that I ran last night before installing 4.17.4}. ?Now

Martin, The locobuffer can be on either the protected or unprotected side and doesn't care about railsync. The manual shows the Locobuffer as only an example of something that can be trusted to be on

Mike R. Yes.? It is consistent.? The only comment I would make is that the Digikeijs help page did not say anything about connecting to Lenz via ethernet. I am guessing this is because it doesn't

Martin, Where does Digitrax say this? Dick :)