开云体育

Dave, Your example of using two pins from the Tortoise is call 'Two Sensor' feedback. Since there is a dead band in the contacts on the motor, you will get a period of 'out of correspondence' where

Martin, Why will a LocoBuffer-USB not work on a 'protected' section of the LocoNet if that is closer to your panel computer? I thought that 'protected' and 'unprotected' just has to do with Railsync

I've never heard of reflashing Digitrax decoders so would have to say no. Most issues if you haven't fried the decoder can be fixed by doing a factory reset of the decoder. With your roster entry

Dave JMRI (PanelPro) certainty supports the NCE AIU board, which connects to the Cab Bus (not the DCC Accessory Bus). The Switch-8 connects to the DCC Accessory Bus. There is one error in your

Hi all, Is it possible to add a digitrax decoder firmware reflash option to a future JMRI update? I have a few now that a uhlenbrock intellibox seem to have corrupted the firmware in. Cheers Stu

Paul, I am looking forward to hear about your findings. The script I was testing it with only changed - or tried to change - the CAN Detector Messages flag, leaving all the LocoNet flags set as the

I would like to know, in the scenario shown in the link below, would detection of the switch alignment, show in Panel Pro, using the tortoise’s internal switches, connected to NCE accessories as

I will look into that.

I don’t know if this will help, but a local N scaler purchased one of BLI’s Mikes recently and was unable to get it programmed. I found a brief mention on another forum to try the following: “

Tim, The earlier BLI locos used QSI decoders and it was essential to turn off Verbal Acknowledgement of CV writes (set CV62 to 0)or it would mess up CV read/write operations with JMRI. It affects

Tim, The SPROG IIv3 has a reputation as one of the best devices for reading CVs (provided you use Direct Mode - some older firmware had a issue with Paged Mode). Direct mode is best for modern

Richard, what is the audio feedback on a BLI? How do I check for it, can I turn it off? Tim

I am sorry if this has been mentioned. Has the audio feed back been turned off? Seems everytime I read a BLI decoder the engine address changes and needs to be reset. But why I don't know. I have just

How is the Acer configured to talk to the NUC? I.e. what’s the JMRI connection type used there? Bob

It may take editing and saving the preferences again to make sure the profile being read has the right form for the baud rate and that is the issue. Once the profile is rewritten with the new details

Thank you very much for the help. I feel a little silly about using the wrong parser :) When I used the name, I got a real small text not in the place I wanted. I have starter to create text boxes in

Following up on a previous thread about 'distributed' computing power... Win 10 Acerpc (4.17.3) talking to a Win 10 NUC (4.16).? The NUC is directly connected to the DCS240 and has the layout in a

Thanks for all the input Group Dave, my apologies for not answering your earlier question.? As far as I can recall, the CVs that fail are random.? I clean my programming track and loco wheels with

Marc, Correct. Only if they weren't loaded correctly by the OEM, retailer, end-user with LokProgrammer. That's not the reason. There are several reasons: - Some panes (such as the Function Map) are

Tim, I always do. I did ask you before whether the CV numbers that fail are: - Consistently the same? Can indicate that the CV is not supported by your decoder. - Random? Usually a sign of poor track