开云体育

Is the problem involving JMRI 4.16 and Locobuffer USB a factor? If so, upgrading to 4.17 is apparently the fix. /g/Digitrax-Users/message/220164 Jan

I used Steve Todd's JMRI image to install working JMRI on my newish Raspberry Pi 3B+. PanelPro is finally working properly on it with simulated connections to my railroad. WiThrottle is working, too.

Your 3 files are now located here: /g/jmriusers/files/ProblemsBeingWorkedOn/Haltz -- Peter Ulvestad JMRI Users Group Moderator - http://www.jmri.org ( http://www.jmri.org ) Tam Valley

Rob, The general procedure is to select new locomotive, identify the decoder (or if you know the decoder just select it). Once identified switch to the CVs sheet and read full sheet. However, You

Haltz, By going to the Files folder for this group and clicking twice on the word "Uploaded" near the upper right corner of the page, two sorts are provided. The first sort gives us the oldest upload

I seem to have this problem with one train. The train is a 7 car turn.I use 7 moves in the outgoing yard. When I build the train I show only 6 cars.I cannot find anything in the build report to answer

Don, The profile selector option is stored in settings:PanelProConfig2.properties and settings:DecoderProConfig3.properties. For Windows, settings: is mapped to "C:\Users\<username>\JMRI”. In Linux

Don W, One important detail: do you still have the original panel file? Second, a comment about the preferences. I think you said you were using CMRI, if so, read on, if not skip the rest as not

James, If you’ve built the HDL keypad as part of the HDL command station, you may be able to watch the loconet packets with JMRI (assuming the HDL setup transmits the packets to LocoNet). That might

One way to do something like this would be to turn on the Wiki feature of the group. By selecting the “subscribers and moderators can view and edit” (which means the public can’t, i.e. you have

I don't recall saving the loaded panel after the error messages, but as it was weeks and many attempts ago, cannot say for certain. The Preferences >> Config Profiles dialog has an option to display

I think that the most likely cause of the service track failure-to-program is that the Digikeijs DR5000 doesn’t understand the particular LocoNet commands JMRI is using to request a programming

Thank you both for your replies. Bob: I do not have any hand held throttles to use for testing, as the layout is intended to be computer controlled entirely. As to incompatible commands, I have

I would like to know if there is a step by step way to read in a locomotive into JMRI? The reason I ask is I was reading in some of my locomotives to place into the roster and didn't do anything, that

Hi Mike, MERG CBUS is a Layout Control Bus running over a CAN Controller Area Network. Each module has a node number, so it can be identified and programmed. Messages between modules are based on a

Hello fellow modelers. It appears that many of us are either confused with a concept, a feature of jmri, or how to implement a scheme or strategy. Might I suggest a "how to" depository of solutions,

James, Unless you have "special hardware", NMRA's "programming on the main" operations are unable to _read_ CV values. This is a limitation of the original NMRA specification, and is a limitation of

Richard, that sounds great. Any chance of getting the panel (xml) and/or script files?

Hi Mike, The Model Electronic Railway Group (merg.org.uk) might well prove to be a source of useful information for you. Their members have designed and produced a range of kits, available only to

Are you trying to do this (use a track and separate DC locomotive on the output of the decoder) as a temporary thing while testing/programming the decoder? Or do you want to do it more permanently? If