开云体育

Jan, My question is regarding the following:Digitrax as probably all decoders have default functions assigned, IE. F1 = Bell.If i connect something to the F1 pad on a decoder, does that replace the

I have a spur – ACME – that holds only one car (47’ long). At the start it has one car in it (a 30’ car). I have two trains – Sawdust Turn and Southbound Throughout – that service this

Also check if the decoder is LOCKED. John

Jim When you have selected the decoder - in the top left of the screen is "RESET" =- click on this and follow the prompts. Gerry -- Gerry Hopkins MMR #177 FNMRA Great Northern Downunder

I cannot change CV 8 to reset a decoder. Can DP do a reset? Thanks. Jim K

Anyone help me with this? ?My computer is an Mac (Apple)?laptop and when I talk about moving the icons I mean after building the train moving the train marker from the first location on the route to

I made a a mistake but I know I down loaded 4.16, I feel pretty sure I used the long address. Did program a ESU decoder prior to the ROCO loco with a simp chip. I can program the ROCO train using my

I am having some trouble with Decoder Pro. This is occurring now with two separate command stations, being: (1) a Digikeijs DR5000; and (2) a Hans Deloof HDM18C. Both are connected via USB (albeit not

Hi George, Up until last Thursday the “Read All Sheets” function has worked perfectly for me. As you’ve also mentioned, JMRI is no longer able to find my decoder manufacturer ID on any of my

Hi Mick, I guess I should have mentioned I’ve owned the Digitrax PR4 and JMRI software for 2 years now and this has never happened in the past. Short pulses while JMRI is reading information from

Steve, This album shows the dialog windows that can occur for NX actions. /g/jmriusers/album?id=94433 NX Options.png dialog occurs when re-selecting an existing route. This makes it

Thanks Dave. I was able to change your config to use four simulator connections and get your panel to load. I still get some errors creating sensors, but since your question is regarding turnouts, I

Hi Mike, First, I can guarantee that you do not have 4.16.2, as it does not exist. As to your issue, the four digit number is most likely (unless it starts with at least a zero) a long address. If

Spuds: Good wifi signal: yes. Not much in the wat of interference besides me in the vicinity of the layout. Most times, the phones have line-of-sight to the router. Tried YouTube on one of the phones,

Thank you again Jan for the information. I was not aware of this prior to purchasing and installing the device. If I had, I would have thought about this differently. Maybe there might be a JMRI app

Hi Jan, I did in fact download the most recent one and it is the same thing. When you look at the picture that is uploaded, it looks fine, but when you print a list or see the icons or on one of the

I recently down loaded 4.16.2 and went to Sprog decoder pro 1 placed a ROCO loco and read the decoder type it gave Zemo ,I tried to program the 03 standard readout to a four digit cab number. The

LNWI is not a substitute for Locobuffer plus a computer's wifi and does not work with JMRI. LNWI is a device that interfaces Loconet to wifi by setting up its own wifi network completely independent

Rob: I recall from a few months ago a post about picture orientation and also that the issue was resolved in an update. Do you have the latest JMRI version? Jan

Sam: On my S7 airplane mode kills all transmitters in the phone, including wifi. Are you sure your phone wifis are active (the ripple icon showing several ripples and not greyed out or an empty