开云体育

Hi Don, Yes, read Steve’s doc. If I remember correctly, if you are able to connect via Wi-Fi then connect to the Raspberry Pi Hotspot and use VNC to connect and configure the Pi as needed. If you

Thanks Dan, Yes, closing the window and re-opening does keep the column formatting the same. Sometimes I just keep opening windows using the PanelPro screen instead of using the task bar. Thanks, Bob

Thanks, Victor and others, I got an HDMI cable today, and have the JMRI home page displaying on my monitor! The USB mouse works, too. :--) I suppose I'll need a keyboard connected to the Pi to

I should also note that column widths and order are not saved for the edit schedule window.? The details for a window are saved by window name, and in the case of edit schedule, the window name

Richard, The GPIO pins that are available by default in JMRI are the GPIO pins on the RaspberryPi itself. The chip on the servo boards provides another set of GPIO pins that are used to control

Hi Bob, If you resize a column it should stay that way unless you open a second window.? For example if you open the Cars window, the window location, and all of the columns get saved when you close

This is a piddly suggestion (isn't it nice we are at the point where we can entertain piddly suggestions?);? when I resize a column in, say, cars or schedules, the column would stay resized unless

Hi Don, I use Steve Todd's image with my EasyDCC system and a PTB 100 connected to my program track.. I also have a Raspberry Pi connected to the EasyDCC.? I access via wired and wireless using the

Thanks Paul, My board should arrive tomorrow so I can start experimenting. I have already prepared my JMRI preferences (running on the RPi) by adding the Raspberry Pi Foundation as a connection, and

Don, Tsunami 2, Econami, ESU V4/Select/5 all make extensive use of CVs in the range 257-512 inclusive, the range specified by the NMRA for Indexed CVs (multiple pages of CVs 257-512, referenced by the

Dave, Upon reflection perhaps it might be more logical and therefore aid the learning process if it was the CPE that took the lead and PE was accessed through CPE. That would separate out one use of

Dave, Nicely put together! As always and as we have talked about before I believe some of the confusion comes about because of the use of the multiple uses and intended meaning of the word

And if you follow the ‘remix’ then there are adjustable microswitches and a base that uses less material. I do like this design over the MERG group one that I have some of, and will probably go

Hi, Steve, I intend to use your free image with my Pi. I have downloaded and unzipped the image, written it to a microSD chip, and installed it in my new Pi. The power supply arrived today, so I

Just to put a period on this question, the LocoBuffer USB arrived today.? I installed it per the instructions, and it works like a charm.? That pretty much says to me the LocoBufferII was either

Ken: I Installed 4.17.3ish and that has fixed the problem Sorry I couldn't respond faster this install is on a club layout and I have to go there to do anything, so sometimes it takes me a bit...I

PJ, The daily build, I posted a link earlier today, has the fix for the baud rate on CMRI issue. 4.15.8 through 4.17.2 have issues with selecting the baud rate. -Ken Cameron, Member JMRI Dev Team

All; To remove some of the confusion regarding the adjustable bracket cap, here is a direct link. https://www.thingiverse.com/thing:3778126 Dan

You can have the parts printed by a third party if you don't have a printer.? If I wasn't on vacation I'd print them for you. You can also alter the print design to oblate the micro switch holes (or

Thank you muchly, Dan! You have not only saved me from a few hours of design time, but you've even improved my design with micro switch mounts! How thoughtful! Ken Moordigian Jackson Livery