开云体育

If you want to see what’s being sent to your command station, you can turn on JMRI’s monitor for that connection. There’s a “show raw data” button that will give you the entire message. For

Test version 4.17.2 of JMRI/DecoderPro is available for download. This is the next in a series of test releases that will culminate in a production release, hopefully in December 2019. There have been

Thanks Bob. I guess I was thinking that there must be a low-level function that actually creates the entry in the data packet that's sent to the command station. Sounds like the only way for me to

Hello Jason, Your project sounds very similar to what I am investigating. A few comments: * The SparkFun Servo pHAT for Raspberry Pi has an optional 5V mini plug so you can power the servos separately

Update for Larry and other Kindle users: I bought a Fire 7 on Prime Day so I could (hopefully) figure out why EngineDriver was no longer showing up in the Amazon App store. I went through the same

Thank you, Bob & Paul. ?There's just so much to learn about JMRI (and then all the other bits of software it can interact with...) Like much of Europe & the US at the moment, a heatwave here means

Steve, Well, I've learned two things reading this post.? Will have to try out 'Safe' and 'Alternate Section'.? ?Is 'Alternate Section' ok to use as the end of a Transit? Roger

Sorry fingers out of control. ?Should be iMac! ?(or almost anything you can run JMRI on!) Paul

Have a look at MQTT. ?The JMRI implementation of this is described here ( http://jmri.org/help/en/html/hardware/mqtt/index.shtml ) and supports turnouts. ?You will need to run a broker, but your PI

Torben Running "safe" solves this. A train will not leave it's current section until the next safe section is clear. That's normally a passing point that has alternates. Steve G. -- Sent from my

Hi Steve Thanks for letting me know. - That's certainly a shame, as it does restrict auto running to single lines Torben

Thank you all very much! I will try these solutions. You're going to say I'm stupid but I just discovered the photo section....... We learn every day? :-)

The problem might be that DCC needs precise timing to work correctly and it may be difficult to process something else. For example to smoothly move servo you need to move them degree by degree during

Gary, Thanks. Now we know your environment and JMRI settings. However there is no additional information about the error. The next step is to upload the panel xml file to the group’s

Dave, Here is the error log 2019-07-25 18:01:20,787 util.Log4JUtil ? ? ? ? ? ? ? ? ? ? ? ?INFO ?- * JMRI log ** [main] 2019-07-25 18:01:22,642 util.Log4JUtil ? ? ? ? ? ?

(I’ve kept all the below for context, mostly because I don’t understand it enough to quote just part of it) Could you create a USB connection to the ESP32 chip and then use communications

Gary, When the error occurs and the panel loading has completed, go to Help >> System Console. Click on the Copy to Clipboard button and paste the results in a reply. This will provide some context

I am getting this error when loading my panels. I do I go about correcting this? Garyy Ratay

Ken and Ken, Cab ID issues don't prevent a response to the AA command, which is handled entirely in the NCE USB (unless you have already issued another command that is trying to get through to the

Francois, I've added photos on how to add Block Contents Labels to your panels.? You will need to be in a newer version of JMRI I believe as the older version wont work. I'm running 4.15.9 test