开云体育

I have some Strange Behavior with DP. 1. Loco is running on main but DP says no response from loco when trying to do POM.2. Sound levels don't change when DP values are entered.3. The same goes for

?????????????? protocol? mel perry [email protected]> wrote:

Paul, It could be updated every time a decoder is programmed. At least it would be a start for those who keep permanent lash ups.? Or just add a column that the user could enter the consist address.

Just to add another view (which perhaps is an extension of what Richard will soon find with his Pi Servo pHAT approach) ... I use DCC++ on an Arduino Mega with motor shield to command the locos on my

I've not played with the train tracking in a few years, but here is a basic issue that existed with the blocks doing the tracking. This relied on the occupancy detection to work. In case of a short on

Ken C, I talked with Ed at NCE about LEDs not working. Since my PC recognizes the Silbar software in COMM 4 port, Ed thinks problem in the USB interface. I am sending it to NCE to be checked out. I

Thank you very much Christopher and Dave! I'll check it tomorrow! Have a good day (here in France ;-))

Chris, You are describing Control Panel Editor, not Layout Editor. Dave Sand

In Layout Editor for "Indicator Track" and "Indicator Turnout" items there's an option to "Display Train Name when occupied" available when you create or edit the item. I have one item in each OBlock

Hello Group, Thank you to all who commented on my earlier post where I was trying to connect servos directly to my Arduino Mega running the DCC++ sketch. With everyone's help, I have decided to

Thanks Ken, This sounds like the issue I am seeing ... So today I am trying a different approach. Rather than connect the servo to the Arduino Mega with the DCC++ sketch, I have ordered a Pi Servo

Yes, I am trying run this on the same Arduino Mega that is running the DCC++ code. I just assumed that the DCC++ base station code, when configured for the outputs would handle one servo. Did I assume

I use Layout Editor and OBlocks? ;-)

Is it worth mentioning that the answer will vary depending on if you use Layout Editor and OBlocks or Panel Editor and Blocks? -- Chris White

Hello, Sorry for my approximate language: -) Roger replied, and I think I'll do the same by using Dispatcher. Is this the only solution? My goal is to see on the screen in the layout panel which train

I know of one layout that uses CATS and OperationsPro to move the loco icon, so it can be done. Dan

See my original comment, you can pull and set out anywhere in the train's route.? It doesn't matter if the train is a turn. Dan

Ken S, I presume you mean the data LED's on the USB board? Seeing them flash is sometimes tricky. Bigger issues are when they become stuck on, that's a different case of issues. -Ken Cameron, Member

Hello Ken C. Since the LED lights do not work, I am checking with NCE today. I guess the problem must me with the USB interface. I will recap conversation with NCE after I talk with Ed. Ken S

Dave H, Just to remind me, if the cab id is not valid in the USB, we still get the AA command acknowledged, but we'd not be able to talk to the command station, correct? I don't think that is any part