开云体育

Hi Dave Thank you for your continued interest in my layout. I have moved on a bit since your last email to set up additional routes so your comments don't match up exactly with the NX sensors I now

JMRI ver 4.14+Rd060e0b. Java ver 1.8.0_201. JMRI settings NCE, NCE USB, com 3, V7.x.x (also tried V6.x.x), Power cab, N, NCE, 9600 baud. ?USB board has no jumpers installed. ?Windows device manager

Here is pic of the number 4 switch with a DS51K1 installed. These work fine on my layout. https://drive.google.com/file/d/1IHgOX1Qaenx1owQLo-914-fzq7iuuLRe/view?usp=sharing Jay

I’ve been having troubles where my Mac no longer communicates with the layout, which is a PR3xtra, a DCS210, DB210 and two PM42s. I get no errors when starting up PanelPro but when I go to the

Hi Jerry and everyone else, thank you for the feedback so far, ? currently I'm using Jeff Bunza's code scan_sensors.py script to connect the IR / Arduino to JMRI which seems to work without any

I'd be interested in the code too as I am doing this exact same thing

Steve - Bob is right - ?it can get tricky! ?But I am doing exactly what you are looking at: IR sensors at block entry and exit, ?monitored by an Arduino acting as a C/MRI node, talking with JMRI.

Rizwan: It looks to me that you have everything wired correctly and the problem is that you may not actually be sending the trip/close signals from JMRI. (BTW I agree with gs that no harm is done by

Rizwan M I've programmed at least 30 of the?DS51K1.? As I said above - once the yellow wire is connected, it goes into a "listening" mode.? ?The next time a turnout command comes down the rails it

It looks like the group does not allow photos. Jay

Rizwan, I am curious as to why you operated the turnout more than once while in program mode. The instructions say to connect the yellow wire, power on, select address, press C or T to operate and

Fraser, I have been testing some of your other routes. Due to your track plan and sensor placement, there is an issue for some routes such as cc07enter -> cc05enter. Because the left fiddle yard has 4

Hi Paul, I'm happy to test I would like to get it working reliably. I can even provide remote access to a machine if doing direct debugging would be easier/quicker Regards Lee

Using point sensors, like IR sensors, can get complicated. You have to consider things like intermittent activation (if the sensor goes ON/OFF/ON as the train goes by), how to handle it if a train

Hi! I would have posted this earlier, I was having issues. Here is a pic of one of my Kato #4 with a DS51 installed. This has been in operation for over 3 years now. Jay

Thanks for more helpful pointers guys. I wish I had better news to share but the decoder wouldn't take an address even with the changed wiring. Jim is still right that my earlier connection was wrong

Hallo, tried to reset ESU Lopi 4 and got that message above. Apparently the values were resetted though. But what does that message mean ? Thanks and regards Joern

Blocks are not directly supported by Logix. You have to use the assigned sensor to represent the block in Logix. Dave Sand

I'll add that the driver was updated in March 2019, so you likely need it. I downloaded and ran the installer. Then when I connected the hardware it went through a couple of cycles (watching the

Hi,? for various reasons I opted to use IR sensors for detecting where my loco(s) is on the track and for block occupancy,? not realising (because i'm new to this) that JMRI seems to only be able to