开云体育

Hi How to edit the profile manager list?? I use? several profiles, one for the rolling stock and one for the test stock. Other profiles for editing, programming, operating. These profiles are linked

Hi Dave Thanks for offering to look at this. Zip file uploaded to Fraser Smith folder in Problems Being Worked On. I have a few NX routes set up in there. Try from Plat 1 (sensor is in vee of SL7 to

Rizwan, A few comments, now we know you have a SPROG, and having looked up some information on the DS51K1. Your SPROG can't find the decoder. Communications on the DCC track bus are one-way. The

@Dave Sand. Thanks for the detailed write-up. Really appreciate the effort you put into writing detailed instructions for a newbie. Unfortunately, it did not work as expected. I've added comments

Please ignore these emails. I forgot i have to open a panel first before entering data and i save the data when i save the panel Tony

@Bob. I don't use a Digitrax system in between. I have connected the DS51K1 directly onto the turnout itself (as per

The word Arles should be tables Also I opened a second loconet connection in preferences and then erased it going back to just the original connection. Tony

Ps: its panel pro 4.14 Tony

i started a new profile. Digitrax simulation. APPLE MAC BOOK PRO i open tools/tables/ turnouts i enter IT1 , LT1 ?I CLOSE THE WINDOW i open the window, everything is there. ?I close panel pro. i

Rizwan, Although I don’t have a Pi-SProg or the accessory decoder in question, I think I know the procedure. It may work and it may not but it might be worth a try. The following assumes that

Folks, As of JMRI vers 4.15.5, more flexibility has been added to the MQTT topic with more flexibility to come and the payload can have a JSON string or plain text. So the direction we are going is

Have you read down thru here - - - http://www.jmri.org/help/en/html/hardware/loconet/Digitrax.shtml I personallyy run NCE. Also do a google search for your decoder and see what is discussed. so -

Rizwan, All DCC decoders will have a default address when shipped. NMRA Standard S9.2.2 says that a bare unfitted loco decoder should have short address 3 as the default when sold. But that doesn't

@Jay, Thanks for trying to help. I have read the Turnouts documentation. As I've mentioned, I've tried to "Add Turnouts" or directly control it using "Turnout Control" with the? Yellow wire connected

I struggled with this on a raspberry pi. I think the roster peport is a .png file which is a postscript file. The printed report is not very flexible at all,,,i believe. I use a screen capture on

Fraser, I only use Full Interlocking. As far as I know, Turnouts and Signals is like full interlocking without the block allocation. I have not had any issues with signaling when a route has been

Hi Peter, he was asking how to input the switches into JMRI. He said he tried but could not get them to "stick". I felt that was a good start for him. Jay

Hi I have been looking at setting up NX routes on my Layout Editor panel and see that there are three options:Turnouts only, Turnouts & Signal Masts and Full Interlock. Turnouts only I quite

Can the list be exported as a CSV file? You can then import it into Excel and format how you want before printing. Sent: 26 May 2019 21:24 To: [email protected] Subject: Re: [jmriusers]

Rizwan, - Turnouts have their own separate DCC address range (1-2044). - Signals have their own separate DCC address range (1-2044). - Loco short addresses are a separate DCC address range (1-127). -