开云体育

Seasons greetings to all Where's the collection plate located? John Stewart Birmingham

HP, crew: If HP is seeing a nominal 5V on the output pins no matter what has been sent to it it's not seeing commands to turn on the output ie pull to ground. But wait... a couple more basic

Since *) Polling works *) Sensors work *) The SM2 works *) You say the ground are good *) You’ve checked the output voltage *) And the init message was "Init ua=0 type=X DL=0 NS=1 CT: 16”, which

I need a diagram of that board. If you have one then e mail it to me jlefevre1@...

Tim, One more point. Engine sounds (start-sound, shutdown-sound and notch-sounds) _must_ have the same audio format. The format should be either 8-bit-mono or 16-bit-mono, but not a

one input wire ... turnouts operate from sm2's if you force voltage change from 5 volt to 0 volt ... and vice versa ... but output board voltage is 4.98 volts at connected bits and doesn't change

I have misplaced my SM2 board diagrams. How many input wires to the board does the SM2 require. One for coil A output and one for coil B output or just one wire that when on throws to coil A and when

sorry ... I just had temporary power connected to the rs232/485 board ... wire had come loose ... so now we're back to heart beat on susic ... red & yellow led's nearly solid on ...and red & yellow

It sounds like you have only a single connection to your layout. In that case, there are ways to do it where one program connects to the other to share that connection, but there’s a simpler

It seems they fight for the same connection, is there a way to to have them both up at the same time? Thanks! David

For the record, what I found was two issues, together it gave a blank for the roster list. But I could see the roster.xml file was sizeable. Then the console showed issues with multiple Jackson jar

Git Blame shows that this line was commented-out (disabled) by Ronald Kuhn in December

The log indicates that most likely your existing roster entries were created with a different version of the decoder definition file (hence all the "WARN - Did not find locofile variable..."

Thanks to everyone that helped resolve my issue. A special thanks to Ken Cameron. He said my issue was a little unusual and called me and fixed the issue. It was definitely above my pay grade. Happy

Thanks for the answer, Dave.? I appreciate your time.

To all I would agree with all the comments. An amazing program along with great support from the team and all users. Using this program has provided hours of enjoyment in operating my model railway.

I upgraded to version 4.14 and still seeing the errors trying to write to the CV400+ variables

When is the decoder specs going to be available for the Bachmann 2-8-0 Sound Value decoder by Soundtraxx? Thank you, Max Robbins

Like Joel, done, thanks for the reminder Greg and I echo his comments of appreciation to the JMRI developers and contributors to this group discussion. JMRI is an amazing program and this group is an

Thanks, I will do that! I did not know there was a newer version