开云体育

Chris: Replacing DCC with MQTT seems like a solution looking for a problem to solve. An enormous advantage of DCC is that is standardized and supported by a large range of suppliers of many types of

Was having the same problem even with a booster installed. The advice I got from this group was to eliminate the booster. It worked like a charm. I was trying to program a new Bachmann 2-8-0 and

Neither adding or editing work. I will try again tomorrow with 4.13.7ish

Yes

Ken I had already tried that, doesn't work.

Have you read the information at this link? <http://jmri.org/help/en/html/doc/Technical/ProfileFileStructure.shtml> It will help you understand the JMRI file structure. -- Dave in Australia

Jan,? I don't necessary agree with you on that. MQTT can certainly send data to an engine and drive it via an Arduino or whatever. You can also use it to send strings to an arduino that controls a

Hi Is this when adding the icon or editing it. Adding had a problem which will be fixed in next test release or 4.13.7ish as off this morning. Edit icon should work. Steve G.

I was thinking of all the non obvious but necessary setting of bits in a huge and growing range of configuration registers. Eg? Loco/4234/lights/ditch /on Andy --- This email has been checked for

Another point: The Steve Todd image alone may not be suitable for the Pi-SPROG. The SPROG DCC image applies the miniuart-bt-overlay which may affect the serial comms.

Clay, The basic concept of direction detection is watching the sequence of block changes. If BlockA is active and BlockB becomes active, then the implied direction is A-B-etc. A layout editor panel

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* APB Demo.xml *Uploaded By:* Dave Sand

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* ABP Demo.xml *Uploaded By:* Dave Sand

Paul, From your paths, your custom icons would be: E:\My Docs\MR general\JMRI data & Docs\Pseudo_Dartmouth_2018\resources\icons That should show from the second entry in the icon finder tool. -Ken

My pleasure.? You have been so helpful throughout this journey - and now I am enjoying myself with JMRI! Do you accept virtual beer?? I doubt whether I will ever meet you to buy you a real one!

Andy:? As I understand it, DCC provides the fundamental data transfer along the track while MQTT is a higher level system that manages the information to be put in or read from the DCC data stream.

If DecoderPro can't uniquely identify the decoder, there are several possibilities: 1) The manufacturer doesn't provide enough CV-readable information to uniquely identify the decoder. 2) We don't

I also discovered an existing bug in IdentifyDecoder that kicked in when there was a retry. I've fixed that as well and written more tests. All takes time for a senior citizen... -- Dave in Australia

Trying to look at the big picture here. Putting JMRI aside for the moment Surely this is a much better way of sending commands to trains via the rails instead of the current DCC protocol? Andy ---

Code done. Just doing the JavaDoc today and checking SpotBugs CI tests etc. But I doubt it will make it into the V4.14 production release. We're trying to stabilise the code for that now and it will