开云体育

Paul D, Yes I restarted JMRI at each attempt. Not curing it though.

Hello all, I would like to configure JMRI for my new Atlas MP15DC. When I purchased the unit it came with a NCE decoder. When I try to identity the decoder in JMRI it lists all the models. Does

Ken, I tried that with same non-working result

Paul T, I just had similar issue in a few threads back. Ken is right but my changes did not show up until I restarted PanelPro. Moving files then looking in PanelPro without a restart will not

I’m sorry I haven’t been clear. I understand the case when you can change the programming in the nodes. Is there a case where you _cannot_ change the programming in the nodes? For example, you

Good thought. ?Perhaps they only "play nicely" with a Bachmann command station. ?I was able to set the addresses several months ago, but may have been so eager to get the locos in operation that I

Bob, The broker doesn’t care what the payload is at all. The only thing the broker is doing is handling the topics received and sending them out to “nodes” that subscribe. All it does is broker

Thank you! That detail is helpful. I see how people writing their own code for e.g. Arduinos can handle JMRI standardizing on particular text to publish. Certainly, we can have JMRI use reasonable

Bob, Answering some of your questions, though I'm not an expert on this so hopefully others will add or correct as need be.. The existing JMRI turnout sends (unless very low-level configuration is

I believe the expected path would be: ...\user\profile\etc\resources\icons\gwrsigs\manyicons Meaning the resources tree is expected to be in the same directory as the profile expects the user files

I am unable to get a new folder of icons.gif to work in LE. I have searched the forum for other peoples similar issues and noted various recommendations. I have put the icons in 5 different folders

Corrected file loaded perfectly on both computers/operating systems/Java versions. *Thank you.* I have uploaded?some files for your inspection in the?/Photos/cvc-identity-constraint.4.2.2/ folder.

Good morning. After 4 hours of watching the lights blink on usb but not comms with loco, I loaded the exact same software and setup in a notebook, away it went. So at least determined no the nce

You certainly have some setup-specific issues. JMRI will uniquely identify any modern ESU decoder, except the Essential Sound Unit (because I can't complete the definition for it until ESU gets the

Hi Paul, Thanks for responding.? Here is my log.? I hope you can find something. Best Wishes Graham

Graham, Can you send me an XpressNet monitor log with timestamps and raw packets enabled that shows this? Hornsby choose to do things quite differently than every other XpressNet implementation and

Same for me.. definitely not ok or normal. Eventually the delays get so bad it shuts down. -- RockPro - San Diego, CA Raspi2 B+,?SPROG3, BDL168 & 10 switches on a 4x8

How much control does the layout owner have over the payload? I.e. can sensor data from layout to JMRI (almost always) be configured to match something specific? Or does JMRI need to be configured

MQTT payloads (states) can be an integer, string, or even JSON. I think though if it can be done we should be using language that is easy ?to understand. Such as on, off, closed, thrown, etc.,

Dave, After locating the correct directory and adding an icon, the new icons would not initially show up in the CPE edit icon catalog. I then closed CPE and restarted it. After doing that, the